Specifications

51
4.18 IR: JDS (090001)
To download the User Manual and get a list of the RS232 protocols view file JDSManualAndProtocols
on your EyeOn Technician CD.
This device must be changed over to Serial Mode before connected to the server.
1) Remove any static charge from your hands by touching a piece of metal.
2) Remove the two Phillips head screws on the rear panel of the IR-XP2 and carefully slide out the
circuit board.
3) Locate the four jumpers just behind the RS232 jack on the edge of the circuit board.
4) Move jumpers J1 and J2 to the RS232 position.
5) Slide the circuit board back into the enclosure.
6) Replace the rear panel.
7) Connect one end of the provided data cable to the RS232/AUX jack on the rear panel of the IR-
XP2.
8) Plug the DB-9 Serial Adaptor into any of the RS232 cords on the server.
The rest of the setup for the JDS will be done in the admin setup screen.
For advanced diagnostics you can view file JDSManualAndProtocols on your EyeOn Technician CD
to get a list of the RS232 protocols. This devices connects at 2400 BPS 8-N-1.
You might need to use a Stereo 1/8 MiniJack cable
See the diagram on the following page.