Specifications

57
Start by crimping a connector onto the communication cable, using the T568-B standard. (Note that
this wiring standard must also be used at the switch or router.) Performing this step first is prudent,
since you won’t be able to set the touch screen aside, once the power has been connected.
Prepare the 16/3 power cable by stripping away 1.25” of the outer insulation. Next, strip 1/4” inch of
insulation from each wire. After insuring that each terminal has been loosened enough to
accommodate the wire, insert and secure each wire into the touch screen’s terminal block as shown in
Figure 2, taking care to tug each wire after they have been tightened to insure that they are secure.
Figure 2
Now, simply insert the Ethernet connector into the touch screen’s Ethernet port (shown in Figure 1).
Once this connection has been made, carefully insert the touch screen into the wall mount that was
previously installed.