Specifications

77
Another option is to use Remotes tab to add the commands. You can only do this if you have
programmed in the remote though Managing Remotes. This will allow you to adjust the volume of
RS232 devices. Depending on how quickly and drastically the volume changes per command, you
may have to add the command to the mood a couple of times and then set a wait timer. Different
devices may vary; use trial and error to determine the best fit for your system and device. For
example, with the Integra we recommend adding the Volume up command 4 times with a 1 sec Wait
Timer for the VOLUP Mood. The wait timer allows the system to properly adjust before sending
another VOLUP command.
For example, if you selected Resettable “YES” and then hit the remote rapidly the volume would
continue to rise even after you have stopped pressing the button. This happens because the
amount of time it takes you to press the remote is shorter than the time it takes to adjust the volume.
Each time you press the button the remote sends a command to turn the volume up 4 times. Instead
of waiting a second, the mood cancels itself and runs again sending the volume up command. So if
you hit the remote 5 times in one second the volume would continue to rise for a couple of seconds
after you were done. You will want to make sure you setup the Mood for Resettable “NO”.
When you are done setting up the Events for the Mood hit Save Mood.