Specifications

After you finish setting up the Input you will have to set up the outputs. Begin by selecting the check

boxes that correspond with the Address(es) of the Output(s) cards that are being used. Hit Update

Outputs before you continue setting up the outputs.

Select the Device of each output and then name it accordingly. If necessary select a sensor.

Garage

Select this for the output that controls the garage. You will also need to select the Sensor for this

option. This will tie the garage sensor to the correct controlling device.

Gate Type 1

This option works similar to the Garage option in that it causes the output relay to energize for 5

seconds before falling back to a de-energized state. For most gate controllers, this causes the gate to

fully open for a given amount of time (determined by the delay programmed into the gate controller by

the gate installer), before closing automatically.

Gate Type 2

With this option, once the output relay is energized, it will stay in an energized state until it is

commanded to de-energize by the EyeOn control software (via the touch screen, scheduling software,

etc.). By using this option, the end-user can choose to leave the gate open for extended periods of

time, which is perfect for the occasional party.

Voice Siren

Select this for the output with the voice siren.

Outside Siren

Select this for the output with the outside siren.