Specifications

93
Run Status Test
This test is to make sure you are getting good status messages from each light. It also helps you to
double check that you have programmed and named all of the lights correctly. Begin by pressing
Start Over
next to Run Status Test. After starting this test, switch each light on and off. This action
should remove the light from the list. Press Test Results
next to Run Status Test, to see which lights
are still listed. Locate the lights on the list and test them. Refresh the page to see if the light was
removed from the list. Once they are all gone that means you are getting status from each light.
Also if you forgot to program a light, but turned it off and on for the status check anyway, it will show
up at the bottom of the results page. Unfortunately, since there is no name associated with these
overlooked lights, you will need to determine which lights you missed and program them into the
system.
Important!
Always make sure you click on Stop Test at the bottom of the Test Results page when
you have completed your tests. If the test is left running, it will cause more server load and could
decrease the efficiency and speed of the system.