6144 Indoor PTZ Dome Camera with Fan 6154 Outdoor PTZ Dome Camera with Fan & Heater 9
The 6144 (Indoor) and 6154 (Outdoor) high-resolution Pan Tilt Zoom Color Dome Cameras are perfect for high-end surveillance systems. Their built-in multi-protocol decoders allow the cameras to be controlled using either Pelco D or Pelco P protocols. Built-in heating elements and cooling fans ensure continued operation even when under extreme ambient conditions.
Dimensions Units: mm 6144 6154 120.0 120.0 215.5 99.5 224.5 99.5 71.1 196.5 71.1 52.0 Ø101.0 52.0 Ø101.0 118.4 118.4 141.7 141.7 Accessing the DIP Switches There are several configuration DIP switches located underneath the dome cover of the camera. Please follow the steps below to safely remove the dome cover. After the configuration switches have been set, follow these steps in reverse order to reinstall the dome cover. See the following page for configuration details.
DIP Switch Settings ON DIP 1 2 3 4 PTZ Protocol Settings... These DIP switches select the PTZ protocol and baud rate that will be used for communication between the camera and PTZ controller. Follow the table below. Auto Detect Pelco-D(2400) Pelco-P(4800) 2400bps 4800bps 9600bps 19200bps ON 1 Off Off Off Off Off On On DIP 1 2 3 4 5 6 7 8 ON DIP 1 2 3 4 5 6 7 8 4 2 Off Off On Off On Off On 3 Off On On 4 Off Off On Example...
Installation Note: The installation of the 6154 camera is shown below. The 6144 comes with a different mount, but the installation is otherwise identical. Wall Mount 1. Drill a hole for wiring to exit the wall. 2. Feed camera pigtail through the base of the wall mount. 3. Attach mount to wall with screws. Camera Pigtail 4. Connect camera pigtail to the base of the camera. 5. Secure the camera to the mount using the set screw. Set Screw BNC connector Wire Extensions (not included) RS-485 Connector 6.
Trouble Shooting Problem No motion and no video output Possible Cause Solution Power supply is disconnected or damaged. Check power supply. Replace if needed. Normal Video output Power supply voltage Make sure to but abnormal motion is too low. use the correct power supply. Move the power supply closer to the camera. 6 Have motion control, Faulty coax but no video connection. Check with cable tester or verify cable by sending known good video signal through it.
*Specifications Image Sensor: 1/3” Hi-Res CCD Picture Elements: NTSC: 768x494 Resolution: 500 lines S/N Ratio: More than 48 dB Min Illumination: 0.7 Lux @ F1.8 Electronic Shutter: 1/60s - 1/120,000s Iris Control: Automatic/Manual White Balance: Automatic Gamma Characteristic: 0.45 Focus: Auto/Manual/One push Optical Zoom: 10X, f = 3.8 to 38.00mm Min. Focal Distance: 1.000mm Digital Zoom: Off/On (X2 - X10) Zoom Speed: 1.67 sec: Wide to Tele Angle Field of View: H: 51.
Channel Vision Technology will repair or replace any defect in material or workmanship which occurs during normal use of this product with new or rebuilt parts, free of charge in the USA, for two years from the date of original purchase. This is a no hassle warranty with no mail in warranty card needed. This warranty does not cover damages in shipment, failures caused by other products not supplied by Channel Vision Technology, or failures due to accident, misuse, abuse, or alteration of the equipment.
