Technology Digital RF Modulator Installation Instructions

ManualsBrandsChannel Vision ManualsHome Theater SystemDigital RF Modulator E-1200

E SERIES 1200

Installation Instructions

234 FISCHER AVENUE z COSTA MESA, CA 92626

(714) 424-6500

z (800) 840-0288 z (714) 424-6510 FAX

http://www.channelvision.com

z E-Mail: sales@channelvision.com

Summary of content (6 pages)

PAGE 1
E SERIES 1200 Installation Instructions 234 FISCHER AVENUE z COSTA MESA, CA 92626 (714) 424-6500 z (800) 840-0288 z (714) 424-6510 FAX http://www.channelvision.com z E-Mail: sales@channelvision.
PAGE 2
Channel Vision ! CAUTION Tested To Comply With FCC Stan- RISK OF ELECTRIC SHOCK FOR HOME OR OFFICE USE DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER. PROPER VENTILATION REQUIRED. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONAL. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
PAGE 3
E Series 1200 Basic Setup company input and the CVT combiner. This prevents the CVT signal from propagating back up the input line. Another way to prevent leakage from your system is to cap all unused coax cable ports on you network with appropriate terminators. Cable or Antenna AV In 3102 Filter Modulator Channel Vision MULTI ROOM VIDEO TECHNOLOGY CVT - 15PIA RF Out HS-2 Bandpass filters stop unwanted frequencies while passing all others along.
PAGE 4
2. When laying out your system, there will be approximately 5dB of signal loss per 100' of RG6. 3. Be sure ALL of your splitters and amplifiers are broadband. Splitters should be 5MHz to 1GHz, and amps should be 40MHz to 1GHz. 4. Check and make sure that all televisions are set up for the proper frequency spectrum (i.e. UHF or cable). 5. Make sure that the channels you want to modulate on have “clean snow“. No lines or interference. 6.
PAGE 5
2. leakage may occur or if the shielding braid is touching the center conductor. Install model CVT-15PIA amplifier after the combiner. Grainy Modulated Channel : Good Picture on the Cable Channels 1. Disconnect cable channels from the system and check the modulated channels. A) If the modulated channels are good, use a low pass filter to "clean-up" the incoming frequencies to be modulated.
PAGE 6
Channel Vision Limited Warranty Channel Vision Technology will repair or replace any defect in material or workmanship which occur during normal use of this product with new or rebuilt parts, free of charge in the USA, for two years from the date of original purchase. This is a no hassle warranty with no mail in warranty card needed.