DVR User Manual

OPERATION

② Press the “PTZ” button to control pan, tilt and zoom functions of PTZ camera.

③ Use the § , ¨ button to pan left and right and the © or ª button to tilt up and down.

④ Turn the SHUTTLE ring to zoom in and out.

⑤ Use the (-) or (+) button to focus. Or press the (AF) button for auto focusing.

⑥ Press the PTZ button again to exit the PTZ mode.

** Please refer to 6.6.4 PTZ setup of LINK menu, page 74.

5.2.12.2 PTZ PRESETTING

① Press the “PTZ” button to enter PTZ mode.

② Press the “PRESET” button to enter PRESET mode and “PTZ(PRESET)MOVE”, OSD will be

displayed on the left side of the monitor.

③ Move to the desired preset location using the “NUMBER” buttons.

④ Press the “PRESET” button again and “PTZ(PRESET)SET”, OSD will be displayed on the left

side of the monitor.

⑥ Press the “NUMBER” button to set up the revised presetting.

PRESETS

- A preset is a user-defined camera position using pan and tilt, zoom, and focus commands.

This DVR has the Programming capacity for 16 preset locations for 16CH.

This DVR has the Programming capacity for 8 preset locations for 8CH.

This DVR has the Programming capacity for 4 preset locations for 4CH.

- This DVR has RS-422/485 terminal block telemetry port on the rear panel.