Instruction Manual

The SIK SIK both interface with the Channel Vision
telephone entry controllers, P-0920 and P-0921 to provide audio and video
communication with the front door. Using a 2-conductor wire, connect the Telephone
Entry Controller to the empty screw terminal block on the door station (see diagram).
For the camera, use CAT5 (POE for power) or a coax for analog video and 18/2 wire
-6xxxA-xx and -7xxxA-xx ’s
Channel Vision Compatible (SIK-xxxxA-xx)
Panasonic (SIK-xxxxP-xx) Compatible
Strike
Active
Ring
Intercom
Active
12VAC
#
or
*
No CO
Strike
Time
3/5 rng
1
2
3
PowerIntercomUnlock
Door
ChimeCO Input
Phones
TELEPHONE ENTRY CONTROLLER
CO Input
Telephones
Model
P-0920
PRO
CHAN N EL
TM
VI S I ON
From Telephone
Service Provider
House
Telephones
12VAC
500mA
Using a 2-conductor wire, connect the door
phone output of your Panasonic KSU to the
empty screw terminal block on the door station
Channel Vision's Panasonic models are a compatible replacement for the Panasonic
KXT30865. They are an attractive alternative to the standard plastic door station sold
by Panasonic. This product interfaces with Panasonic’s KSU phone systems to
provide communication with the front door.
Connect to the
terminals marked
“TO SYS”
From Telephone
Service Provider
System Phones
Panasonic
KSU
4
5
1 / 2
2 / 3
4 / 5
6 / 7
9 / 0
1 / 2
2 / 3
4 / 5
6 / 7
9 / 0
ST-C5IDS
S G P
500ft.
max
The diagram below shows how to connect the SIK-xxxxC-xx to Channel
Vision’s CAT5 Whole-House Intercom system. When the button is pressed on
the SIK-xxxxC-xx the ST-3000 Intercom Stations will generate a door chime.
Pressing Answer/End will open communication with the SIK-xxxxC-xx. Model
SIK-6xxxC-xx includes an analog 960H color camera and SIK-7xxxC-xx
includes an IP camera.
Channel Vision Compatible
( -xxxx )
CAT5 Intercom
SIK C-xx
P-0930
PRO
CH ANNEL
TM
VI SION
Model
P-0930
Whole-House Intercom
Page Out
Page Trigger
IR
Emitters
+15VDC
Power
Link
In
Link
Out
Hub
A
B
C
D
Room 1 Room 2
Room 3
Room 4 Room 5
Room 6
ST-3000
Press here to
answer door
Using CAT5 wire, connect the
P-0930 to the 110 connector
on the door station
SIK-xxxxC
SIK-7xxxA
SIK-7xxxP
1 / 2
2 / 3
4 / 5
6 / 7
9 / 0
Using the Access Keypad
Power Light: (Green)
IMPORTANT: if power
light does not illuminate,
immediately disconnect
power supply and check
for correct polarity.
Status Light: (Red)
Keypad
1 / 2
2 / 3
4 / 5
6 / 7
9 / 0