Instruction manual

CAUTION
If burner does not light OR if burner flame is accidentally extinguished, turn knob to OFF,
wait 5 minutes, try again. If the burner does not ignite with valve open OR if burner flame
is accidentally extinguished after lighting, gas will continue to flow out of the burner and
could accidentally ignite with risk of injury.
Burner Flame Check
• Light burner, rotate knob from HIGH to LOW. You
should see a smaller flame in LOW position than
seen on HIGH. Always check flame prior to each
use. The air damper (D) mounted on the back of
your burner helps to control the amount of
primary air that mixes with the LP gas. A blue
flame with little or no yellow flame provides the
best heat. Adjust the air damper by turning it
clockwise or counterclockwise until the desired
flame is achieved.
Holes in Burner
Good
Bad
Yellow
Blue
Yellow
Blue
D
Air Damper
12
Lighting Instructions
Do not lean over LP cooker while lighting.
1. Turn regulator control valve to OFF
position.
2. Fully open LP tank valve.
3. Slowly turn ON the regulator control
valve. Push transmitter button or button
on receiver. If ignition does not occur,
light a match and place it over burner.
Slowly turn ON regulator control valve.
DO NOT stand with head or arms over
cooker.
4. If ignition does not occur in 5 seconds,
turn the burner control(s) off, wait 5
minutes, and repeat the lighting
Procedure. Curing of paints and parts
will produce an odor only on first use.
Ignitor Button
Turning LP Cooker Off
• Turn all knobs to OFF position. Turn LP tank
OFF by turning hand-wheel clockwise to a full stop.