Instruction manual

Electrode/Ignitor Assembly Instructions
Ground wire terminal must be
between electrode flange and wall of stand.
NOTE: Tip of electrode wire should be 1/16”-1/8”
from burner for proper ignition. Bend
electrode wire slightly if necessary.
10. Insert the electrode into the side of the cooker
stand, behind the ignitor panel. Secure the electrode
and the Ground wire to the stand with one #10x1/2”
self-tap screw.
The
end of the electrode wire should be above the edge
of the burner.
Electrode wire
Burner
Electrode
Ignitor
panel
Ground wire
17
9. Place module on flat
surface and remove
front cover. Insert two
AAA batteries and
reassemble front
ensuring that the rubber
gasket remains in place.
Secure with four screws
removed in step 2 .
+
+
-
-
(2 AAA)
Make sure rubber gasket remains in place.
CAUTION
A jumper wire is attached to receiver terminals to prevent shock during battery
installation and receiver attachment to stand. Do not remove jumper wire until
step 11 is completed.
Electrode flange
Ground wire
terminal