Instruction manual

12. Place the ignitor cover over the ignitor and

attach to ignitor panel using two #10x1/2” self-tap

screws.

Ignitor cover

11. Attach ignitor module to ignitor panel using two

#8x1/2” self-tap screws. Ignitor Button must be

CAREFULLY pulled through hole in Ignitor panel

before fully tightening the screws.

Remove and discard jumper wire on terminals.

Keep discarded wire away from small children.

Ignitor

panel

Ignition Module

Ignitor

Button

13.

Attach heat shield to ignitor cover

Using

The ignitor wire has a

connector at one end and a

connector at the other end. Push

the round connector into the

ignitor through the lower left hole

in the ignitor cover. Push the flat

connector onto the electrode tab.

Connect ground wire to right

terminal.

flat

round

two #10x1/2” self-tap

screws.

Ignitor wire

Ground wire

Flat end

Left terminal

Heat

Shield

Heat shield screws