Instruction manual

Troubleshooting • Electronic Ignition System
Problem
No spark
using
transmitter.
No spark
using
Receiver
Module.
Possible Cause
• Push button on receiver.
• Transmitter out of range.
• Receiver window blocked.
• Electrode not in correct position.
• Loose electrode wire.
• Batteries installed incorrectly.
• Dead batteries.
• Faulty transmitter.
• Transmitter out of range.
• Receiver window blocked.
• Electrode not in correct position.
• Loose electrode wire.
• Batteries installed incorrectly.
• Dead batteries.
• Faulty Module.
Solution
• If electrode sparks, troubleshoot
transmitter. If electrode does not spark,
troubleshoot receiver.
• Reposition transmitter.
• Check for obstructions between
transmitter and receiver.
• Make sure electrode is within
of burner without touching burner.
• Make sure electrode wire secured tightly
to electrode.
• Make sure that the batteries
Are installed
Correctly.
• Replace
batteries.
• Replace
Transmitter.
• Reposition transmitter.
• Check for obstructions between
transmitter and receiver.
• Make sure electrode is within 1/4” of
burner without touching burner.
• Make sure electrode wire secured tightly
to electrode.
• Make sure that the batteries are
installed correctly.
• Replace batteries.
• Replace transmitter.
1/16”-1/8”
28