Use and Care Manual
26
• Place heat tents over tube burners by inserting tabs into slots in front of firebox. Opposite ends of heat tents rest on pins in back of
firebox.
NOTE: There is no heat tent over sear burner.
13
Heat T
ent
Back of Firebox
Pin
Heat T
ent
Front of Firebox
14
• Place cooking grates onto grate rests.
• Insert ends of Warming Rack pivot wire into holes in sides of gril lid. Insert ends of Warming Rack leg wire into holes in sides of
firebox.
NOTE: Pivot and leg wires, running side-to-side, should be under wires running front-to-back. If pivot and leg wires are on top,
Warming Rack is installed upside-down.
• Unscrew ignitor cap and place AA battery into ignitor slot with positive end (+) facing outward. Replace ignitor cap onto ignitor.
Warming Rack
Leg Wire
Cooking Grate
Pivot Wire
AA Battery
+
-
+
–
Sear Burner