Owner`s manual

16 463232103
A Division of W.C. Bradley Co.
P.O.Box1240
Columbus,GA319021240
Problem
No sparks appear
at any electrodes
when ignition
button is pushed;
no noise can be
heard from spark
module.
No sparks appear
at any electrodes
when ignition
switch is pushed;
noise can be heard
from spark module.
Sparks are present
but not at all
electrodes and/or
not at full strength
Possible Cause
Batterynotinstalled
properly.
Deadbattery.
Buttonassemblynot
installedproperly.
Faultysparkmodule.
Outputlead
connectionsnot
complete.
Outputlead
connectionsnot
complete.
Arcingtogrillaway
fromburner(s).
Weakbattery.
Electrodesarewet.
Electrodescrackedor
broken"sparksat
crack".
Check Procedure
Checkbatteryorientation.
Hasbatterybeenused
previously?
Checktoinsurethreadsare
properlyengaged.Buttonshould
travelupanddownwithout
binding. 
Ifnosparksaregeneratedwith
newbatteryandgoodwire
connections,moduleisfaulty.
Areoutputconnectionsonand
tight?
Areoutputconnectionsonand
tight?
Ifpossible,observegrillindark
location.Operateignitionsystem
andlookforarcingbetween
outputwiresandgrillframe.
Allsparkspresentbutweakorat
slowrate.
Hasmoistureaccumulatedon
electrodeand/orinburnerports?
Inspectelectrodesforcracks.
Solution
Installbattery(makesurethat"+"and"–"
connectorsareorientedcorrectly,with"+"end
downand"–"endup.)
ReplacebatterywithnewAAsizealkalinebattery.
Unscrewbuttoncapassemblyandreinstall,making
surethreadsarealignedandengagedfully.
Replacesparkmoduleassembly.
Removeandreconnectalloutputconnectionsat
moduleandelectrodes.
Removeandreconnectalloutputconnectionsat
moduleandelectrodes.
Ifsparksareobservedotherthanfromburner(s),
wireinsulationmaybedamaged.Replacewires.
ReplacebatterywithanewAAsizealkaline
battery.
Usepapertoweltoremovemoisture.
Replacecrackedorbrokenelectrodes.
Troubleshooting Electronic Ignition