Use and Care Manual

Front brace

Tank heat shield

Left side panel

Right side panel

Upper back panel

Insert tabs into slots

#8x3/8" self-tapping

screw

Note: Some parts omitted for

clarity of illustration

Leave wires outside when attaching

tank heat shield to front brace.

Inside of cart, insert rear tabs (w/o holes) of tank heat shield into slots on the bottom of upper back panel, shown A.

Attach front tabs (w/ holes) of tank heat shield under front brace using two #8x3/8" self-tapping screws, shown B.

ignition module

Electronic

Left side panel

Nut

NOTE: Switch terminals are larger than electrode terminals

and should only be installed in location shown as (a), (b).

(a)

(b)

Cap

AA Battery

Connect each of the wires from main burner electrodes into the back of Electronic Ignition Module. Total (2)

connections. Connect the two wires [(a) and (b)] from switch wiring harness into the back of the Electronic

Ignition Module. Total (2)connections, shown A. Unscrew the cap and nut from electronic ignition module. Attach

electronic ignition module to the cart left side panel with the nut, shown B. Insert AA battery into electronic

ignition module, negative (—) end first. Replace the cap, shown C.