Use & Care Guide ModeJ: 415.16139110 I
CALIFORNIA If you smell gas: PROPOSITION 65 2. Extinguish any open flame. 1. Combustion by-products produced when using this product contain chemicals known to the State of California to cause cancer, birth defects, and other 3. Open lld. reproductive 4. If odor continues, keep away from the appliance 2. This product contains chemicals, including lead and lead compounds, known to the State of California to cause cancer, birth defects or other reproductive harm. |. Shut off gas to the appliance.
For Your Safety. ............................................................. 2 KENMORE ELITE FULL WARRANTY Grill 2 If this grill 2 within two years from the date of purchase, call 1-800-4-MYHOME®to arrange for free repair (or replacement if repair 2 proves impossible). Information Product Safety Center ............................................. Record Information ........................................ Symbols .............................................................
LP Tank * The LP Tank used with your grill requirements: must meet the following * Use LP Tanks only with these required f x, II • NEVER store a spare appliance (30.5cm) capacity _I LP cylinder or in an enclosed under or near the area. (diameter) maximum. measurements: 12" x 18" (45.7 cm) (tall) with 20 lb. (9 kg.) * LP Tanks must be constructed and marked in accordance with specifications for LP Tanks of the U.S.
LP Tank Exchange * Many retailers that sell grills offer you the option of replacing your empty LP tank through an exchange Use only those reputable exchange companies that precision fill, test and certify their tanks. Exchange tank only for an OPD safety feature-equlpped tank described in the "LP Tank" section of this manual. service. inspect, your as Connecting Regulator To The LP Tank l. LP tank must be properly assembly section.) 2. Turn all control secured onto grill.
Leak Testing Valves, Hose and Regulator 1. Turn all grill control knobs to OFF. 2. Be sure regulator is tightly connected to LP tank. 3. Completely open LP tank valve by turning OPD hand wheel counterclockwise. If you hear a rushing sound, turn gas off immediately. There is a major leak at the connection. Correct before proceeding parts at 1-800-4-MY-HOME Hold coupllncj nut and regulator 4. Brush soapy solution picture below: as shown for proper connection to LP tank valve. by calling ®.
For Safe Use of Your Grill and to Avoid Serious Injury: • Do not let children operate or play near grill. • Keep grill area clear and free from materials • Do not block of grill. • Check holes in sides or back burner flames covered kind. space. space such as carport, patio, (Unless briquets " or ceramic are supplied NEVER use in garage, or under an overhead • Do not use charcoal burn regularly.
Main Burner lcjnltor " Open grill lld during Lighting. • Do not lean I. Turn OFF all 2. Turn ON gas 3. To ignite knob 4. Press and the grill Gas Burner main to the Valves. burner, _ Match Lighting the Main Burners 1. Place match into match holder (hanging from RH side or LH side of the cart). 2. Strike the match and position lit match through cooking grates as shown in Figure A. 3. Position lit match next to far left main burner. push in and turn the burner position.
SideburnerIgnltor Lighting CAUTION Do not lean over grill while lighting. 1. Open sldeburner lld. Turn ON gas at LP cylinder. 2. Turn sideburner knob to the HI position, push and hold ELECTRONIC IGNITOR button. 3. If sideburner does NOT light within 5 seconds, turn knob to OFF, wait 5 minutes, then repeat lighting procedure. Match lighting the Side Burner - Figure D 1. Open the sideburner lid during lighting. 2. Place match in match holder. Strike the Match. lit match close to the side burner. 3.
Cleaning the Main Burner Assembly Follow these instructionsto clean and/or replace parts of burner assembly or if you have trouble igniting grill. 1. Turn gas off at control knobs and LPTank. 2. 3. 4. 5. Remove cooking grates and heat diffusers. Remove electrode from burner by prying the clip away as shown in Figure A. Electrode should remain in firebox. Remove hitch pins and flame carryover tubes from front of burners as shown in Figure B.
Grill Halogen Light LIGHT OPERATION 1. Make iNSTRUCTiONS sure light switch on the control 2. panel is in the "OFF" 3. position. 2. Connect light plug to an extension cord, then plug the extension cord into the outlet on the wall. 3. Turn the light switch to "ON'. Light cordf for outdoor = Keep any electrlcal suppJy cord away from any heated surface. = Use the shortesf use length extension cord required.
Cleaning the Lens 1. Prior to cleaning, make sure the light switch is in the "OFF" position and the light plug is disconnected from the power supply. 2. Do nat dean temperature the glass lens when warm. Allow to coal before cleaning. Sudden change in may cause cracking of the glass lens. 3. Use a damp towel to clean the surface of the glass lens. 4. Allow the lens to dry before reconnecting llght switch to the "ON" the light plug to the power supply and turning the position.
1 1 LEFT SIDE SHELF G523-1100-W1 48 1 BOTTOM 2 1 FASCIA, LEFT SHELF G523-OO51-W1 49 2 DOOR 3 1 RIGHT SIDE SHELF G523-1200-W1 50 1 TANK SHELF ASSY G523-4100-W1 4 1 FASCIA, RIGHT SHELF G523-OO52-W1 51 1 LEFT SIDE PANEL G523-0800-W1 5 1 TOP LID G523-O100-W1 52 1 RIGHT SIDE PANEL G523-0900-W1 6 1 INNER INSERT, F/TOP G523-OOO1-W1 53 2 LOCKING G523-0028-W1 7 1 TEMPERATURE GAUGE G518-OO75-W1 54 2 FIXED CASTER 8 1 BEZEL, F/TEMPERATURE G503-OOO2-W1 55 1 ELEC
® 14,464224211
insert flange on left side shelf into side shelf brackets, shown A. Attach left side shelf rear using two 1/4-20xl/2" screws, 7mm lock washers and 7mm fiat washers, shown Bo Attach left side shelf front using three 1/4-20xl/2" screws, 7mm lock washers and 7mm fiat washers, shown C © 4-20x1/2 y.5 '' screw 7mm lock washer Qty.5 7mm fiat washer Qty.
insert flange on right side shelf into side shelf brackets, shown A. Attach right side shelf top using two 1/4-20x3/4" screws, 7mm fiat washers, 7mm lock washers and 1/4" nuts, shown B. Attach right side shelf rear using one 1/4-20x3/4" screw, 7mm lock washer and 7mm flat washer, shown C. Attach right side shelf front using two 1/4-20xl/2" screws, 7ram lock washers and 7ram flat washers, shown D. \ 4-20x3/4 y.3 4-20xl/2" ty.2 '' screw screw 7mm flat washer Qty.5 7mm lock washer 7mm lock washer Qty.
Install heat diffusers by sliding one end of each heat diffuser into slots at front of firebox and resting opposite end on pins at back of firebox. Make sure to install the shorter heat diffuser in A position, and install the two longer heat diffusers in B and C position. Heat diffuser Place cooking grates onto the firebox as shown, insert the three wire ends at rear of warming holes in back of firebox. Front wires of warming rack rest on sides of firebox.
Place sideburner grate into sideburner shelf, aligning grate legs with holes in shelf. On back of grill, slide grease tray into opening in lower back panel. U CAUTION Failure to install grease tray will cause hot grease to drip from bottom of grill with risk of Nre or property damage.
H Unscrew electronic ignition first. Replace the cap. cap on cart right side panel. Insert AA battery A_ into ignitor, negative(-) end Battery Electronic Ignition Cap LP TANK IS SOLD SEPARATELY. Fitl and leak check the tank before attaching to grill and regulator (see Use & Care section). Once tank has been filled and checked for leaks, slide tank tray in bottom shelf forward. Fully loosen tank screw at bottom of tank tray. Insert tank into tray with tank valve facing to right side of cart.
install door organizers Back of left door: Attach bag hook by inserting wire ends in the holes on the door, shown A. Attach condiment tray by sliding it onto tabs on lower door back panel, shown A. Back of right door: Attach condiment trays by sliding them onto tabs on upper and lower door back panel, shown B. Attach paper towel holder between condiment trays, shown B.
EMERGENCIES: Jf a gas leak cannot be stopped, or a fire occurs due to gas leakage, Gas leaking from • Damaged hose. • Turn off gas at LP cylinder cracked/cut/burned hose. If the hose is cracked grill valve!hose!regulator. until a plumber or gas technician replace the cause could Discontinue has investigated and the problem. • Mechanical Gas leaking from LP cylinder valve. • Failure of cylinder valve from mishandling or mechanical failure. • Turn off LP cylinder valve.
Troubleshootlng (continued) Burner(s) will not light using ignitor. (See Electronic Ignition Troubleshooting also) ELECTRONIC IGNMON: No spark, no ignition No spark, some ignition Sparks, noise. noise. but not at electrode or at full See Section I of Electronic Ignition See Section II of Electronic See Section III of Electronic Ignition System. System. Ignition System. strength. Burner(s) will match not See _GAS ISSUES:" on previous page. light.
Troubleshooting - Electronic Ignltion SECTION No sparks I appear any electrodes Electronic at when not installed • Check battery orientation. • Install battery properly. connectors Ignition and Button is pressed; no noise can be heard from • Battery • Dead battery. Has battery been used "-" (make sure that "+" are oriented correctly, and "-" with "÷'_ end up end down.) • Replace battery with new AA-size button cap assembly alkaline battery. previously? spark module.
Your Home iiiiiiiiiiiiiiiiiiiiii!ii_Y iiiiiiiiiiiiiiiiiiiiii _ iiiiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiiiii For troubleshooting, product manuals and expert advice: managemylife wv, rw.managemylife.
