Assembly Instructions

3
4
Attach the Electrode Wire and the Ground
Wire to the Ignitor.
Feed Wires through hole in Side Handle.
Screw Ignitor into Handle as shown in
detail A.
Assemble Side Handle and Ground Wire to
Bottom using two
Attach the Electrode Wire to end of Electrode.
10-24x3/4’’
screws, 10-24 nuts and fiber washers
per handle.
Rest the notches at ends of Heat Plate on
handle screws inside bottom, as shown B.
Place Wind Shield onto burner tube, as
shown B. Attach Wind Shield to burner tube
with one #8x3/8'' sheet metal screw, as
shown C.
Lid Handle
Lid
Cooking Grate
10-24x3/4’’
Screw
Qty. 4
Heat Plate
Side Handle
Ignitor
10-24x3/4’’
Screw
10-24
Nut
Flat Washer
Qty. 2
1/4-20x1/2’’
Screw
Qty. 2
10-24x3/8’’
Screw
Qty. 4
Fiber Washer
Qty. 2
Fiber Washer
10-24x3/8’’
Screw
1/4-20x1/2’’
Screw
Flat Washer
10-24
Nut
Qty. 4
Hinge Bracket
10-24 Nut
Electrode Wire
Ground Wire
Fiber Washer
Fiber Washer
Qty. 4
10-24
Nut
Qty. 4
Bottom
A
Attach Lid Handle and Heat Shield, F/Handle
using two fiber washers, flat washers and
1/4-20x1/2’’ screws.
NOTE: Fiber washers should be between
handle and lid.
Install Hinge Brackets to inside of Lid using two
10-24x3/8’’ screws and 10-24 nuts per bracket.
Make sure notches in Hinge Brackets are toward
the bottom edge of Lid and are facing the same
direction.
Place Cooking Grate into Bottom.
Place Lid onto Bottom.
to lid
Heat Shield, F/Handle
Electrode Wire
Ground Wire
Wind Shield
C
#8X3/8''
Sheet Metal Screw
Qty. 1
#8X3/8''
Sheet Metal Screw
B
11