How to Guide

OM1515 B ™ & © Char-Griller / A&J Mfg. 3
Leg
ASSEMBLY INSTRUCTIONS
Read all safety warnings and instructions carefully before
assembling and operating your grill.
IMPORTANT HINT: DO NOT TIGHTEN ANY NUTS AND BOLTS UNTIL
GRILL IS FULLY ASSEMBLED.
1. Remove and unwrap the Patio pro and all of its parts from the packaging. Also
remove the ash drawer from the Patio Pro. Place GRILL on its end with damper
opening facing up. Spread if open in order to reach inside to perform the follow-
ing.
2. Insert two BOTTOM LEGS into one CROSSBAR, attached with 1 3/4’ hex bolt and
nut, See below. Repeat this step for another two BOTTOM LEGS and one CROSS-
BAR, see below.
3. Attach LEG BRACES to the outside of one of the LONG and SHORT LEG assem-
blies you just made. See below. Use two 1 3/4" hex bolts and nuts for each LEG
BRACE but only finger tight.
4. Insert all four corners of the BOTTOM WIRE SHELF into the four holes located
near the bottom inside of the four LEGS. See below Next, rotate the LEGS up-
ward until vertical. Important: Make sure the two Long Legs are on the same
end.
Leg Braces
Crossbar
Long Legs
Short Legs