How to Guide

OM1515 B ™ & © Char-Griller / A&J Mfg. 4
5. Attach the other end of the LEG BRACES to the corresponding legs using 1 3/4"
Hex Bolts and Nuts but only finger tight. See below.
6. Attach the WHEEL to the spindle coming out of the SHORT LEGS. Install one
WASHER, COTTER PIN and HUB CAP onto the spindle after the WHEEL. Repeat
this on the opposite SHORT LEG.
7. Stand the CART/LEG ASSEMBLY upright. Attach the bottom half of the BODY to
the CART/LEG ASSEMBLY (make sure damper is on same side as wheels) with
four 1 3/4" Hex Bolts. There are two holes in the front and two in the back of the
grill BODY. See below. Make sure the bolts are facing out with the hex nuts on
the bottom of the leg assembly.
8. Attach WOOD HANDLE with two (2) 1/2” HEX BOLTS with two (2) LOCK WASH-
ERS & two (2) HEX NUTS to BOLTS to center of front edge of hood. Snug tight
with pliers. See Below.
9. Attach SIDE HANDLE (metal rod) to the END of the GRILL above SIDE DRAWER
with (2) 1/2” HEX BOLTS,(@) LOCK WASHERS, and (2) HEX NUTS.
Axle
Wheel
Washer
Cotter Pin
Hub Cap