OWNER’S MANUAL Super Pro™ Charcoal Grill Model # 2121 IMPORTADOR: SERVICIOS HOME DEPOT, S. DE R.L. DE C.V. RICARDO MARGÁIN NO. 605, SANTA ENGRACIA, SAN PEDRO GARZA GARCÍA, NUEVO LEÓN, MÉXICO CP 66267 TEL.: 01 800 004 6633 Keep your receipt with this manual for Warranty. CUSTOMER SERVICE 1-912-638-4724 Service@CharGriller.com Contents of this manual are Trademarked and Copyrighted by Char-Griller | A&J Manufacturing.
CAUTION: Handles are Hot OM2121 C.2 ™ & © Char-Griller / A&J Mfg.
STOP! CALL FIRST! DO NOT RETURN PRODUCT TO STORE. CALL (912) 638-4724 This product has been built to the highest quality standards. Call us should you have any questions not addressed in these instructions, or for service information. Have your grills serial number (located on the back of the grill body or on the leg) when calling. OM2121 C.2 ™ & © Char-Griller / A&J Mfg.
(Pliers and wrench not included) Pliers ITEM 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 OM2121 C.
ASSEMBLY INSTRUCTIONS Read all safety warnings and instructions carefully before assembling and operating your grill. IMPORTANT HINT: DO NOT TIGHTEN ANY NUTS AND BOLTS UNTIL GRILL IS FULLY ASSEMBLED. Step 1: Assemble Long Legs, Short Legs, and Leg Braces as show below then secure the Leg Braces to one set of Long Leg and Short Leg with four (4) 1¾” Hex Bolts and four (4) Hex Nuts.
Step 3: Lay the cart assembly down with the Long Legs on the floor then install the Wheels and Wheel Axle. On one end of the Axle insert the Cotter Pin into the hole on the Axle and snap in the Hub Cap. Slide one Wheel onto the Axle then slide the Axle through the holes on the Short Legs and Bottom Shelf. Complete the assembly by sliding the other Wheel onto Axle then insert the Cotter Pin and snap on the Hub Cap.
Step 5: Attach Damper Circle to the side of the Grill Body with one ¾” Hex Bolts, two Flat Washers, one Lock Washer, and one Hex Nut. Lock Washer Flat Washers Hex Nut Hex Bolt Damper Circle Step 6: Attach the Grill Hood to the Grill Body using the two Hinge Pins and two Cotter Pins provided. Grill Hood Hinge Pin Hinge Pin Cotter Pins Grill Body OM2121 C.2 ™ & © Char-Griller / A&J Mfg.
Step 7: Insert Thermometer through hole in Bezel and Grill Hood (from outside) and secure with Wing Nut. Then attach Hood Handle to the Grill Hood with two 3/4" hex bolts, two lock washers, and two hex nuts. See below. Hex Bolts Thermometer Grill Hood Bezel Hood Handle Lock Washers Hex Nuts Wing Nut Step 8: Insert Smokestack Assembly through the hole on the Grill Hood from the inside of the Grill Hood then secure it with two ¾” Hex Bolts and two Hex Nuts. Hex Bolts Grill Hood Smokestack OM2121 C.
Step 9: Attach Side Shelf to Grill Body with four Hex Bolts and four (4) ½” Hex Nuts. Hex Nuts Grill Body Side Shelf Hex Bolts Step 10: Attach Front Shelf to Grill Body with four Hex Bolts and four (4) ¾” Hex Nuts. Hex Nuts Hex Bolts Front Shelf Hex Bolts OM2121 C.2 ™ & © Char-Griller / A&J Mfg.
Step 11: To install the Warming Rack first attach two (2) 2” Hex Bolts and two (2) Hex Nuts onto the Grill Hood. And attach two (2) ¾” Hex Bolts and two (2) Hex Nuts onto the Grill Body. Then Position the Warming Rack onto the Hex Bolts and Secure it with two more Hex Nuts. Hex Nuts Hex Bolts Hex Nuts Hex Bolts Step 12: Place Ash Pan and Ash Pan Hangers onto Grill Body. Ash Pan Hangers Ash Pan Grill Body OM2121 C.2 ™ & © Char-Griller / A&J Mfg.
Step 13: Place Cooking Grates onto Grill Body then Install the Utensil Hooks underneath each Side Shelf Slab at the front of the Grill. Utensil Hooks OM2121 C.2 Cooking Grates ™ & © Char-Griller / A&J Mfg.
GRILL PREPARATION &OPERATING INSTRUCTIONS PLEASE NOTE: NO RETURNS ON USED GRILLS Read all safety warnings and instructions carefully Before assembling and operating your grill. 1. Cure GRILL prior to your initial use to protect the interior and exterior finish and to prevent unnatural flavors to your first meals. (A) Lightly coat ALL INTERIOR SURFACES (including GRILLS, GRATES, AND INSIDE OF BARREL.) with vegetable oil (spray vegetable oil is easiest but do not use near hot coals or fire).
IMPORTANT SAFETY WARNINGS READ ALL SAFETY WARNINGS AND INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING AND OPERATING YOUR GRILL Use caution when assembling and operating your grill to avoid scrapes or cuts from sharp edges. Do not use gasoline, kerosene or alcohol for lighting charcoal. Use of any of these or similar products could cause an explosion possibly leading to severe bodily injury. Keep children & pets away from grill. Supervision is necessary and do not leave grill unattended when in use.
IMPORTANT SAFETY WARNINGS READ ALL SAFETY WARNINGS AND INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING AND OPERATING YOUR GRILL Do not exceed a temperature of 400 F. Do not allow charcoal and/ or wood to rest on the walls of grill. Doing so will greatly reduce the life of the grill Always wear oven mitts to protect hands from burns. Avoid touching hot surfaces. When opening lid, make sure it is pushed all the way back so it rests against the lid support brackets.
Deluxe Griller 2121 ACCESSORIES ORDER FORM Professional Accessories™ Branded with Char-Griller® Logo ALL TOOLS: STAINLESS STEEL & HARDWOOD HANDLES COVER #5555 Custom Fit, Weather Resistant Protects grill finish Cover Accommodates Side Shelf or Side Fire Box Grill cover #5555 fits with Side Fire Box or Side Shelves TO ORDER Visit: www.chargriller.com or CALL: 912-638-4724 or SIDE FIRE BOX #2-2424 For Charcoal grilling Attaches to grill in minutes FAX: 912-638-2580 or MAIL: P.O.
PROPOSITION 65 WARNING: WARNING: This product and combustion by-products produced when using this product contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. Warranty printed in the manual is not valid for Mexico. P.O. Box 30864 Sea Island, GA 31561 912-638-4724 www.CharGriller.