Full Product Manual

5650/5072_OM_A1

After lighting, observe burner ame and make sure all burner ports are lit.

If burner ame goes out during operation, immediately turn gas off on control panel and gas

cylinder valve. Open hood and let gas clear for 5 minutes before relighting. Clean grill after each

use. DO NOT use abrasive or ammable cleaners, as they damage parts and may start a re.

Side Burner

1. Open lid during lighting. Lid must be open when burner is on.

2. Burner valves must be in OFF position.

3. Open cylinder valve.

4. Push in and rotate side burner knob slowly, about ¼ turn, until a click

is heard. If burner does not light, immediately turn knob back to off

and wait 5 minutes for gas to clear before repeating procedure.

5. After burner ignites, adjust knobs to desired cooking setting.

Shutting off Burners

1. Turn knob(s) counterclockwise to HIGH position, then push in and turn to OFF. Never force

knob without pushing in, as this can damage valve and knob. For side burner, push in and turn

to OFF.

2. Promptly close gas cylinder valve.

3. Close grill hood.

Lighting Burner with a Match

1. Place match in match holder installed on side of grill

housing. Once lit, place ame through cooking grates

near burner ports, as shown.

2. Push in and rotate knob to HIGH position, and burner

should light immediately.

3. Adjust knobs to desired cooking settings.

Observe Flame Height When Lit

View burner ame through ame viewing hole. Flame

should be blue and yellow in color, and approximately

1/2”-3/4” tall on HIGH setting.