Use and Care Manual

C-4

Lighting Burner with a

Match

1. Push in and rotate knob to HIGH position

2. Place match in match holder installed on side of grill

housing. Once lit, place ﬂ ame through cooking grates

near burner ports, as shown. Burner should light

immediately.

3. Adjust knobs to desired cooking settings.

Observe Flame Height When

Lit

View burner ﬂ ame through ﬂ ame viewing hole. Flame

should be blue and yellow in color, and approximately

1/2-inch to 3/4-inch tall on HIGH setting.

Disconnecting the Gas

Cylinder

1. Turn all control knobs to the OFF position and turn the handle on the

gas cylinder clockwise until it stops.

2. Turn coupling nut on regulator in a counter-clockwise direction until

regulator is released from threaded gas cylinder valve nozzle.

3. Place dust cap on cylinder valve outlet whenever the cylinder is not

in use. Only install the type of dust cap on the cylinder valve outlet that is provided with the cylinder

valve. Other types of caps or plugs may result in leakage of propane.

Storage of Appliance

Storage of an appliance indoors is only permissible if the cylinder is disconnected and removed from

the appliance. When the appliance is not in use, it should be covered and stored in a dry, dust-free

environment.

Gas Cylinder

The gas cylinder should not be dropped or handled roughly! If the appliance is not in use, the gas must

be turned off at the supply cylinder. Replace the protective cap on the cylinder after disconnecting the

cylinder from the appliance.