Instructions / Assembly

B-4
Hardware Pack:
HARDWARE AND TOOLS NEEDED
Assembly: Requires 2 people. Get another person to help. Tools Needed: Pliers,
Phillips Head Screwdriver and a 7/16” Nut Driver.
NOTE: Do Not tighten any bolts unless instructed to do so. Tightening too soon
may prohibit parts from tting together. All Hex Nuts should be on the inside of the
grill unless stated otherwise. Unpack all contents in a well cleared and padded
area.
Estimated Assembly Time: 45 minutes
¼-20x 1 ½” HEX BOLT .......................... 4 PCS
¼-20x 3/4” HEX BOLT ........................... 5 PCS
¼-20x ½” HEX BOLT ............................. 46 PCS
2/5” FLAT WASHER .............................. 2 PCS
¼” FLAT WASHER ................................ 10 PCS
¼” 20 HEX NUT ..................................... 25 PCS
¼” LOCK WASHER ............................... 27 PCS
HINGE PIN ............................................ 2 PCS
LARGE COTTER PIN ............................ 2 PCS
SMALL COTTER PIN ............................ 3 PCS
CENTER HINGE PIN ............................ 1 PC
SCREW ................................................. 3 PCS
#10-24 X 2/5” SCREW .......................... 6 PCS
HUB CAP ............................................... 2 PCS
CARRIAGE BOLT................................... 1 PCS
WING NUT...............................................1 PCS
SHOULDER BOLT...................................4 PCS