Installation Guide

TX 93605 SINGLE ROCKER WITH STAR
AssembleParts
ARM REST
LENGTH: 21.3” x 2pc
LENGTH: 28” x 2pc
LENGTH: 35.6” x 2pc
LENGTH: 22.5” x 1pc
ROCKER RUNNER
LOWER SUPPORT BEAM
x 1pc
SEAT PANEL
x 1pc
BACK PANEL
SCREW: S04-4 x 2pc
x 4pcNUT & BOLT: N08-8
0.3” x 3.1”
BACK
VERTICAL LOG
1
LENGTH: 25.6” x 2pc
FRONT VERTICAL LOG W/DOWELED
3
LENGTH: 28.3” x 2pc
DIAGONAL
LOG
2
4
5
B
NUT & BOLT: N08-12
x 16pc
0.3” x 4.7”
A
C
7
6
8
STEP 1: Assembling the Rocker Arm Frame
Take one piece of the following parts with a letter
“R” behind each number: 1, 2, 3, 4, 5 (”R” = RIGHT)
1: Part 1 to part 4
2: Part 2 to part 3
3: Part 3 to part 1
4: Part 4 to part 2
5: Part 5 to part 2 and 3
Use indicated hardware, directed by diagram.
REPEAT steps 1 through 5 above using
parts labeled with a letter “L” (LEFT)
after the part number.
STEP 2: Assembling the Bottom Half
Take assembled SEAT PANEL (7) and one of the arm frames, keep the arm frame
standing and attached the SEAT PANEL (7) to the inside of the arm frame, secure with
the indicated nuts and bolts.
Insert the other arm frame
on the other side and
secure loosely with
nuts and bolts.
Take the lower support
beam and secure
under the seat between
the arm frame with
nuts and bolts.
STEP 3: Assembling the Upper Half
STEP 4: FINISH
Once the bottom half is finished,
take the BACK PANEL (8) and
place it gently on part 4 of the
arm frame.
Secure with indicated hardware
in the diagram.
A
8
A
Tighten all nuts, bolts,
and screws once
every part and
assembled pieces
are in place.
Congratulations
on your assembly!
1. Do not tighten bolts until fully assembled.
2. Recessed holes to face outward.
3. Insert bolts with washer and secure with washer and nut.
4. Pre-checked side must always face downward or inward.
IMPORTANT: READ CAREFULLY BEFORE BEGINNING!
Durable log construction.
Exclusive Char-log finish and design
Patent pending crack resistant design and process
Special Char-log heat curing, preserving, finishing
Process resists mildew, mold, and stains
Varnished to preserve Char-log finish
Recessed Hole
Pre-Checked
®
®
®