Stainless Steel FEATURES: - Choose from three cube sizes: small, medium, or large - Built in reservoir drain - Includes a convenient ice scoop
IMPORTANT SAFEGUARDS SAVE THESE INSTRUCTIONS Read and understand all instructions before using the appliance. • • • • • • • • • NEVER put the unit near a hot burner or in an oven. DO NOT use for any purpose other than intended use. ALWAYS place the unit on a firm and stable surface. Ensure that the unit is not placed close to the edge of the table, worktop, etc. where it can be pushed off or fall. NEVER use abrasive cleaning agents or abrasive cloths when cleaning the unit.
OVERVIEW OF COMPONENTS 1. 2. 3. 4. COVER (With a transparent window to allow interior visibility) ICE TRAY ICE SHOVEL CONTROL PANEL A. LCD DISPLAY WINDOW 1. CURRENT CLOCK TIME 2. NO WATER DISPLAY (When flashing: means no water in the unit. Need to pour water in.) 3. ICE-FULL DISPLAY (When it displays: means the ice basket is full of ice-cubes.) 4. ON/OFF DISPLAY (When the unit is turned OFF, this symbol will flash.) (When the unit is turned ON, this symbol will always display.) 5. 6. 7. 5.
UNPACKING YOUR ICE MAKER 1. Remove the exterior and interior packaging. Check that an ice basket and ice scoop are included. If any parts are missing, please contact our customer service department at 888-815-4252. 2. Clean the interior with lukewarm water and a soft cloth. Take out the ice basket and clean it. 3. Find a location for your ice maker that is protected from direct sunlight and other sources of heat (i.e.: stove, furnace, radiator). Place the ice maker on a level surface.
USING YOUR ICE MAKER 1. Open the cover, remove the ice basket and pour water into water reservoir. Keep water level below the level mark. 2. Press “ON/OFF” button on the control panel to turn on the unit to begin the ice making cycle. 3. Select the size of the ice cube by pressing the “Select” button.
HOW TO SET THE TIMER 1. Press the TIMER button first - the default “3.0H” delay time will flash in LCD display window. 2. Then press the SELECT button to select your desired delay time. Each press of the SELECT button will increase the flashing delay time by 0.5 hour. If you HOLD the SELECT button for more than 3 seconds, the delay time will increase very quickly. 3. After 5 seconds, the delay time digit will change from flashing to always displaying. This means the timer program has been set.
TROUBLESHOOTING Ice making cycle is normal but no ice is made. Water temperature in inner tank is too low. Change the water in the inner Tank. Temperature of water is better set between 45 -90 . Ambient temperature or water temperature in inner tank is too high. Please run the ice maker below 90 and pour colder water into tank. Refrigerant liquid leakage. Verify by a qualified technician. Pipe in the cooling system is blocked. Verify by a qualified technician.
WARRANTY IM-12SS / CHARD STAINLESS STEEL ICE MAKER C/O CI PO Box 444 Two Rivers, WI 54241-0444 chardinternational.