Specification

7
1. Open the cover, remove the ice basket and pour water into water reservoir.
Keep water level below the level mark.
2. Press “ON/OFF” button on the control panel to turn on the unit to begin the ice making
cycle.
3. Select the size of the ice cube by pressing the “Select” button. Three sizes: SMALL,
MEDIUM or LARGE can be selected:
SMALL
MEDIUM
LARGE
If the room temperature is lower than 60℉, it is recommended to select the small or
medium ice sign button in order to avoid ice sticking together.
4. The ice making cycle lasts 6 to 15 minutes, depending on the size of the ice cube selection
and the ambient temperature. In the extreme hot room temperature, ice-making time
maybe vary a lot.
5. While the icemaker is on, verify water level periodically. If water pump can’t inject water, the
ice maker will stop automatically, and the “ ” symbol will flash in LCD display window.
Fill water up to the level mark and press “ON/OFF” button two times again to turn on the
unit again. Allow the refrigerant liquid inside the compressor at least 3 minutes to settle
before restarting.
6. The ice maker automatically stops working when the ice basket is full and the “ ” symbol
will display in the LCD display widow.
7. Change water in the water reservoir every 24 hours to ensure a reasonable hygiene level.
If unit isn’t in use, drain all water left in the tank.
Timer Delay Time Range: 0.5-19.5 hours.
Default Delay Time: 3 hours.
When the unit is running, you can set the unit with OFF-TIMER to let the unit stop running after
your set delay time.
And when the unit is stopped, you can set the unit with ON-TIMER to let the unit start to run
automatically after your set delay time, then when you go back home or have a dinner, you can
enjoy the happy life that this ice-maker give to you.
How to set the timer
USING YOUR ICE MAKER
TIMER SETTING
Downloaded from www.Manualslib.com manuals search engine