Installation Manual

Regulatory Approval Conditions for using 241083G Module:
1. Antennas must have a greater distance than 20 cm separation from the transmitting
antenna to the user body during normal operation condition. This device can be used
with Prestta WLAN Embedded Antenna. The specification of the antenna including
antenna gain is shown below.
2. If a different antenna than the original certificated antenna is being use for the final
product, the host will need to consult with Chargepoint, Inc. to verify the condition of
approval applicability.
3. A permissive change from Chargepoint, Inc. is required as part of final system FCC/IC
submission. The WLAN module does not have RF shielding and was tested in stand-
alone configuration. When the module is installed in a new host, it is subject to
additional evaluation.
4. If the host has other transmitters beside from the module, simultaneous transmitting is
not permitted unless a permissive change from the module manufacture is received.
5. For FCC, the label on the final system must include a statement: use “Contains FCC ID:
W38-241083G”. For IC, use “Contains IC: 8854A-241083G”.
6. Labeling requirement for FCC, “This device complies with part 15 of the FCC Rules.
Operation is subjected to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation”.
For IC, “This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.” “Le présent appareil est conforme
aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement."
A user’s manual or instruction manual must be included with customer product.