User's Manual

Regulatory Approval Conditions for using 28010077 Module:
1. Antennas must have a greater distance than 20 cm separation from the
transmitting antenna to the user body during normal operation condition.
This device can be used with Prestta WLAN Embedded Antenna. The
specification of the antenna including antenna gain is shown below.
2. If a different antenna than the original certificated antenna is being use for
the final product, the host will need to consult with ChargePoint Inc. to
verify the condition of approval applicability.
3. A permissive change from ChargePoint, Inc. is required as part of final
system FCC/IC submission.
4. If the host has other transmitters beside from the module, simultaneous
transmitting is not permitted unless a permissive change from the module
manufacture is received.
5. For FCC, the label on the final system must include a statement: use
“Contains FCC ID: W38-28010077”. For IC, use “Contains IC: 8854A-
28010077”.
6. Labeling requirement for FCC, “This device complies with part 15 of the FCC
Rules. Operation is subjected to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired
operation”.
For IC, “This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of
the device.” “Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire
de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement."