User manual

Megabeat Pro
Megabeat ProMegabeat Pro
Megabeat Pro
5-33
The recording mode can be changed as usual highlighting the desired
channel and turning the PAGE/VALUE knob.
Under CHANNEL 1 and CHANNEL 2, you can see the recording mode of
the audio file for the desired channel, which can be:
! OFF: the selected channel will not be recorded, nor played.
! PLAY: the selected channel will not be recorded, but the recording
previously made on the same channel wil be played.
! REC.: the selected channel will be recorded (the new recording will
overwrite any recording previously made).
RECORD : function key to start recording
CUT : function key which lets you skip directly to audio edit function
VOXRMV : function key to use the “VOICE REMOVE FUNCTION”
function. With this function you can remove part of the voice from audio
sources. The available parameters are:
Status : On/Off ( On is enabled only if enabled on both channels)
Voice null : parameter on which it can be useful intervene whether the
voice, in the source, is not perfectly in the center of stereo panorama.
Bass filter : parameter on which you can intervene if the voice, in the
source, is a male or female one (if female you can set a higher value).
Note : The result you obtain removing the voice can change depending on
the quality of the source of the recording. In some instances the
removal will be almost absolute, leaving only any reverb, if present, in
other instances, when the voice has been recorded not only in the center
of the stereo panorama, the removal will be partial or incomplete.
The file recorded with the “VOXRMV” function active will be mono.
5. Before you start the recording, please note that the VU meters you see on
the display show the signal levels on the MIC/LINE 1 and MIC/LINE 2 audio
inputs.