User manual

Megabeat Pro
Megabeat ProMegabeat Pro
Megabeat Pro
5-34
Note If the Vu meters don’t show any signal, please make sure that in the
MIXER page the MIC/LINE input you assigned corresponds to the audio
source actually set.
To select the MIC/LINE input or to equalize the audio inputs please refer
to paragraph “6. MIXER”:
.
Note
! In the MIXER page the REV, EFF and PAN parameters will not be able
to intervene on the input signal.
Viceversa, you will be able to use equalization on the input signal.
! To make inputs adjustment easier, you can skip to MIXER page simply
pressing the MIXER key on Megabeat Pro panel. If you press the MIXER
key one more time you will go back to the main page.
6. To obtain the best from the input levels please use MIC/LINE1 and
MIC/LINE2 faders.
7. To start the recording press RECORD function key.
Note If you don’t want to lose the first moments of an audio source recording,
you must remember that the recording doesn’t start immediately after
you press RECORD function key, but with a little delay (the time
Megabeat Pro takes to “prepare” the audio file on Hard Disk).
The actual beginning of the recording is when the RECORD function key
changes its appearance (the letter changes in “reverse” format).
8. To stop the recording press the STOP key.
Depending on the lenght of the recording, the operation could take some
minute. While you wait, the following message will be displayed: