SDS

ManualsBrandsCharlie's Soap ManualsCleaning42 oz. Oxygen Bleach

Page 4/9

Safety Data Sheet (SDS)

OSHA HazCom Standard 29 CFR 1910.1200(g) and GHS Rev 03.

Issue date 02/13/2017 Reviewed on 02/13/2017

Trade name: Charlie’s Soap Oxygen Bleach

44.2.2

Conditions for safe storage, including any incompatibilities:

Storage

Requirements to be met by storerooms and receptacles:

Store in the original container.

Information about storage in one common storage facility:

Not required.

Further information about storage conditions:

Keep receptacle tightly sealed.

Protect from heat and direct sunlight.

Specific end use(s):

No further relevant information available.

Exposure Controls/Personal Protection

Additional information about design of technical systems:

No further data; see section 7.

Control parameters:

Components with occupational exposure limits:

The product does not contain any relevant quantities of materials with critical values that have to be monitored

at the workplace.

Additional information:

The lists that were valid during the creation of this SDS were used as basis.

Exposure controls:

Personal protective equipment:

General protective and hygienic measures:

Keep away from foodstuffs, beverages and feed.

Immediately remove all soiled and contaminated clothing and wash before reuse.

Wash hands before breaks and at the end of work.

Avoid contact with the eyes and skin.

Breathing equipment:

Not required.

Protection of hands:

Protective gloves

The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.

Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/

the chemical mixture.

Select glove material based on penetration times, rates of diffusion and degradation.

Material of gloves:

The selection of the suitable gloves does not only depend on the material, but also on further marks of quality

and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the

resistance of the glove material cannot be calculated in advance and has therefore to be checked prior to the

application.

Penetration time of glove material:

The exact break-through time has to be determined and observed by the manufacturer of the protective

gloves.

Eye protection:

Tightly sealed goggles

(Contd. on page 5)