Use And Care Manual

Installation
10
Installation of Copper Tube Size (CTS) CPVC Pipe and Fittings Systems
APPLICATOR
Use an applicator that is one-half
the size of the pipe’s diameter.
COAT WITH CEMENT
Primer is not necessary for CTS, however,
check with your local plumbing codes.
Apply a full, even coat of cement on the
outside diameter of the pipe and to the
inside hub of the fitting, and again coat
the outside of the pipe.
JOIN & CURE
While the cement is fluid, insert the pipe
into fitting hub, giving a quarter turn
to ensure an even distribution of cement
within the joint. Allow the joint to cure prior
to hydrostatic testing. See the solvent
cement manufacturer’s recommendations.
6
4
7
CUT PIPE
Cut pipe square with axis.
REMOVE BURRS & BEVEL
Remove burrs and bevel (chamfer)
the end of the pipe 10˚-15.˚
CLEAN AND DRY
PIPE AND FITTINGS
Remove surface dirt, grease or
moisture with a clean, dry cloth.
DRY FIT
With light pressure, pipe should go
one-half to one-third of the way into
the fitting hub. Do not use pipe and
fittings that are too tight or too loose.
3
2
1
5
Installation