Manualshelf

Dimensions Guide

ManualsBrandsCharlotte Pipe ManualsABS DWV Pipe & Fittings1-1/2-in ABS Trap Apt/Nuts
71727374757677787980
78
ConnecTite, Charlotte and Charlotte Pipe are registered trademarks of Charlotte Pipe and Foundry Company.
ConnecTite
®
Limited Warranty
Charlotte Pipe and Foundry Company
®
(Charlotte Pipe
®
) ConnecTite
®
Products are warranted to
be free from manufacturing defects and to conform to currently applicable standards for a period
of ten (10) years from date of delivery. Buyer’s remedy for breach of this warranty is limited to
replacement of, or credit for, the defective product. This warranty excludes any expense for removal
or reinstallation of any defective product and any other incidental, consequential, or punitive
damages. This limited warranty is the only warranty made by seller and is expressly in lieu
of all other warranties, express and implied, including any warranties of merchantability
and fitness for a particular purpose. No statement, conduct or description by Charlotte Pipe
or its representative, in addition to or beyond this Limited Warranty, shall constitute a warranty.
This Limited Warranty may only be modified in writing signed by an officer of Charlotte Pipe.
This Limited Warranty will not apply if:
1) The Products are used for purposes other than their intended purpose as defined by local
plumbing and building codes, and the applicable standard.
2) The Products are not installed in good and workmanlike manner consistent with normal
industry standards; installed in compliance with the latest instructions published by Charlotte
Pipe and good plumbing practices; and installed in conformance with all applicable plumbing,
fire and building code requirements.
3) This limited warranty does not apply when the products of Charlotte Pipe are used with the
products of other manufacturers that do not meet the ASTM standard or that are not marked
in a manner to indicate the entity that manufactured them.
4) The Products fail due to defects or deficiencies in design, engineering, or installation of the
piping system of which they are a part.
5) The Products have been the subject of modification; misuse; misapplication; improper
maintenance or repair; damage caused by the fault or negligence of anyone other than
Charlotte Pipe; or any other act or event beyond the control of Charlotte Pipe.
6) The Products fail due to the freezing of water in the Products.
7) The Products fail due to contact with chemical agents, fire stopping materials, thread sealant,
plasticized vinyl products, or other aggressive chemical agents that are not compatible.
8) Pipe outlets, sound attenuation systems or other devices are permanently attached to the
surface of Charlotte
®
PVC, ABS or CPVC products with solvent cement or adhesive glue.
Charlotte Pipe products are manufactured to the applicable standard. Charlotte Pipe and Foundry
cannot accept responsibility for the performance, dimensional accuracy, or compatibility of
pipe, fittings, gaskets, or couplings not manufactured or sold by Charlotte Pipe and Foundry.
Any Charlotte Pipe products alleged to be defective must be made available to Charlotte Pipe at
the following address for verification, inspection and determination of cause:
Charlotte Pipe and Foundry Company
Attention: Technical Services
2109 Randolph Road
Charlotte, North Carolina 28207
Purchaser must obtain a return
materials authorization and instructions
for return shipment to Charlotte Pipe of
any product claimed defective or shipped in
error. Please refer to the Return Material
Policy on the back of this page for specific
instructions on returning materials to
Charlotte Pipe.
Any Charlotte Pipe product proved to be
defective in manufacture will be replaced
F.O.B. point of original delivery, or credit
will be issued, at the discretion of Charlotte
Pipe. 3/29/17