Dimensions Guide

ManualsBrandsCharlotte Pipe ManualsCPVC Pipe & FittingsCPVC Cap

Charlotte Pipe and Foundry Company (Charlotte Pipe

) warrants to the original owner of

the structure in which its FlowGuard Gold CTS CPVC Pipe and Fittings (the “Products”)

have been installed, that the Products will be free from manufacturing defects and conform

to currently applicable ASTM standards under normal use and service for a period of ten

(10) years. Buyer’s remedy for breach of this warranty is limited to replacement of, or credit

for, the defective product. This warranty excludes any expense for removal or reinstallation

of any defective product and any other incidental, consequential, or punitive damages. This

limited warranty is the only warranty made by seller and is expressly in lieu of all other

warranties, express and implied, including any warranties of merchantability and ﬁtness

for a particular purpose. No statement, conduct or description by Charlotte Pipe or its

representative, in addition to or beyond this Limited Warranty, shall constitute a warranty.

This Limited Warranty may only be modiﬁed in writing signed by an ofﬁcer of Charlotte Pipe.

This Limited Warranty will not apply if:

1) The Products are used for purposes other than the transmission of domestic water.

2) The Products are not installed in good and workmanlike manner consistent with normal

industry standards; installed in compliance with the latest instructions published by

Charlotte Pipe and good plumbing practices; and installed in conformance with all

applicable plumbing, ﬁre and building code requirements.

3) This limited warranty does not apply when the products of Charlotte Pipe are used

with the products of other manufacturers that do not meet the ASTM standard or that

are not marked in a manner to indicate the entity that manufactured them.

4) The Products fail due to defects or deﬁciencies in design, engineering, or installation

of the water distribution system of which they are a part.

5) The Products have been the subject of modiﬁcation; misuse; misapplication; improper

maintenance or repair; damage caused by the fault or negligence of anyone other

than Charlotte Pipe; or any other act or event beyond the control of Charlotte Pipe.

6) The Products fail due to the freezing of water in the Products.

7) The Products fail due to contact with chemical agents, ﬁre stopping materials, thread

sealant, plasticized vinyl products, or other aggressive chemical agents not compatible

with CPVC compounds.

Charlotte Pipe products are manufactured to the applicable ASTM standard. Charlotte Pipe

and Foundry cannot accept responsibility for the performance, dimensional accuracy, or

compatibility of pipe, ﬁttings, gaskets, or couplings not manufactured or sold by Charlotte

Pipe and Foundry.

Any Charlotte Pipe products alleged to be defective must be made available to Charlotte Pipe

at the following address for veriﬁcation, inspection and determination of cause:

Charlotte Pipe and Foundry Company

Attention: Technical Services

2109 Randolph Road

Charlotte, North Carolina 28207

Purchaser must obtain a return materials authorization and instructions for return shipment

to Charlotte Pipe of any product claimed defective or shipped in error.

Any Charlotte Pipe product proved to be defective in manufacture will be replaced F.O.B. point

of original delivery, or credit will be issued, at the discretion of Charlotte Pipe.

3/25/10

FlowGuard Gold

CPVC CTS Limited Warranty

Charlotte Pipe is a registered trademark of Charlotte Pipe and Foundry Company.

FlowGuard Gold is a registered trademark of Lubrizol Corporation.

Testing with or use of compressed air or gas in PVC / ABS

/ CPVC pipe or fittings can result in explosive failures and

cause severe injury or death.

• NEVER test with or transport/store

compressed air or gas in PVC / ABS / CPVC

pipe or fittings.

• NEVER test PVC / ABS / CPVC pipe or

fittings with compressed air or gas, or air

over water boosters.

• ONLY use PVC / ABS / CPVC pipe or

fittings for water or approved chemicals.

• Refer to warnings on PPFA’s website and

ASTM D 1785.