Operating Guide

125
CONNECTITE®
LIMITED WARRANTY
PO Box 35430 Charlotte, NC 28235 USA 704/348-6450 800/572-4199 FAX [phone]
www.charlottepipe.com
Charlotte Pipe and Foundry Company
®
(Charlotte
Pipe
®
) ConnecTite
®
Products are warranted to be free
from manufacturing defects and to conform to currently
applicable standards for a period of ten (10) years from
date of delivery. Buyer’s remedy for breach of this
warranty is limited to replacement of, or credit for, the
defective product. This warranty excludes any expense
for removal or reinstallation of any defective product and
any other incidental, consequential, or punitive damages.
This limited warranty is the only warranty made by
seller and is expressly in lieu of all other warranties,
express and implied, including any warranties of
merchantability and fitness for a particular purpose.
No statement, conduct or description by Charlotte Pipe or
its representative, in addition to or beyond this Limited
Warranty, shall constitute a warranty. This Limited
Warranty may only be modified in writing signed by an
officer of Charlotte Pipe.
This Limited Warranty will not apply if:
1) The Products are used for purposes other than their
intended purpose as defined by local plumbing and
building codes, and the applicable standard.
2) The Products are not installed in good and
workmanlike manner consistent with normal industry
standards; installed in compliance with the latest
instructions published by Charlotte Pipe and good
plumbing practices; and installed in conformance
with all applicable plumbing, fire and building code
requirements.
3) This limited warranty does not apply when the
products of Charlotte Pipe are used with the products
of other manufacturers that do not meet the ASTM
standard or that are not marked in a manner to
indicate the entity that manufactured them.
4) The Products fail due to defects or deficiencies in
design, engineering, or installation of the piping
system of which they are a part.
5) The Products have been the subject of modification;
misuse; misapplication; improper maintenance or
repair; damage caused by the fault or negligence of
anyone other than Charlotte Pipe; or any other act
or event beyond the control of Charlotte Pipe.
6) The Products fail due to the freezing of water in the
Products.
7) The Products fail due to contact with chemical agents,
ConnecTite, Charlotte and Charlotte Pipe are registered trademarks of Charlotte Pipe and Foundry Company.
©2016-2017 Charlotte Pipe and Foundry Company
Testing with or use of compressed air or gas in PVC / ABS
/ CPVC pipe or fittings can result in explosive failures and
cause severe injury or death.
• NEVER test with or transport/store
compressed air or gas in PVC / ABS / CPVC
pipe or fittings.
• NEVER test PVC / ABS / CPVC pipe or
fittings with compressed air or gas, or air
over water boosters.
• ONLY use PVC / ABS / CPVC pipe or
fittings for water or approved chemicals.
• Refer to warnings on PPFA’s website and
ASTM D 1785.
fire stopping materials, thread sealant, plasticized
vinyl products, or other aggressive chemical agents
that are not compatible.
8) Pipe outlets, sound attenuation systems or other
devices are permanently attached to the surface of
Charlotte
®
PVC, ABS or CPVC products with solvent
cement or adhesive glue.
Charlotte Pipe products are manufactured to the
applicable standard. Charlotte Pipe and Foundry cannot
accept responsibility for the performance, dimensional
accuracy, or compatibility of pipe, fittings, gaskets, or
couplings not manufactured or sold by Charlotte Pipe
and Foundry.
Any Charlotte Pipe products alleged to be defective must
be made available to Charlotte Pipe at the following
address for verification, inspection and determination
of cause:
Charlotte Pipe and Foundry Company
Attention: Technical Services
2109 Randolph Road
Charlotte, North Carolina 28207
Purchaser must obtain a return materials authorization
and instructions for return shipment to Charlotte Pipe of
any product claimed defective or shipped in error. Please
refer to the Return Material Policy on the back of this
page for specific instructions on returning materials to
Charlotte Pipe.
Any Charlotte Pipe product proved to be defective in
manufacture will be replaced F.O.B. point of original
delivery, or credit will be issued, at the discretion of
Charlotte Pipe.
3/29/17