How to Guide

INSTALLATION PROCEDURES

• Measuretoverify

that the pipe has

been inserted to

within2”ofthe

insertion line.

• Seetableforrecommendedsetandcuretimes.

• Toensurejointintegrity,onceinsertioniscomplete,the

pulling tool can be used to hold the joint in place dur-

ing set time and also to ensure that the pipe does not

back out.

• Removeexcess

cement from

the exterior. A

properly made

joint will show a

continuous bead

of cement around

the perimeter. If

voids appear suf-

ﬁcient, cement

may not have

been applied and

joint failure may

result.

• Alignallpiping

system compo-

nents properly

without strain.

Do not bend or

pull pipe into po-

sition after being

solvent welded.