Installation & Assembly

ASSEMBLY INSTRUCTION
NOTE: Please consult a qualified electrician if you are not certain of the installation or service.
CAUTION: Before starting the installation or service, disconnect the power by turning off the circuit breaker
or by removing the fuse at the fuse box.
1. Carefully unpack the fixture, lay out all parts on a clean surface.
2. Fasten the mounting strap onto the outlet box by using provided 2 outlet box screws.
3. Then fasten the loop to the nipple A.
4. Using two pliers, twist open links at two ends of the chain as show. Hook one link to the loop and the other
link to the screw collar loop. Close the links. Place a piece of cloth between the pliers jaws and the chain
link to prevent scratching the link finish.
5. Weave fixture wires up through the through the loop, through the chain, through the ring, through the screw
collar loop and through the canopy and through the nipple on the mounting strap.
6. Tie the ground wires from fixture and from outlet box to the ground screw on the mounting strap. Connect
the wire without writing on it (with raised ribs) from the fixture to the white wire (neutral wire) from the
supply circuit. Connect the wire with writing on it from the fixture to the black wire (live wire) from the
supply circuit. Cover the connections using provided wire connectors. Position wires back inside outlet box.
7. Place the canopy over the nipple all the way to the ceiling and tighten the ring onto the screw collar loop
until the canopy is held firmly against the ceiling.
8. Fasten the nipple B to the bushing. Place the bottom cover over the nipple B, using the finial to secure them.
9. Unscrew the socket rings from the sockets. Place the shades over the sockets, refasten the socket rings to
secure them.
10. Install the bulbs (Not included). Turn on the power.