Installation & Assembly

ASSEMBLY INSTRUCTION

SKU#60/4145, 60/4165, 60/4146, 60/4166

NOTE: Please consult a qualified electrician if you are not certain of the installation or service.

CAUTION: Before starting the installation or service, disconnect the power by turning off the circuit breaker

or by removing the fuse at the fuse box.

1. Carefully unpack the fixture, lay out all parts on a clean surface.

2. Fasten the mounting strap onto the outlet box by using provided 2 outlet box screws.

3. Fasten the loop to the nipple A.

4. Using two pliers, twist open links at two ends of the chain as show. Hook one link to the loop and the other link to the

screw collar loop. Close the links. Place a piece of cloth between the pliers jaws and the chain link to prevent

scratching the link finish.

5. Weave fixture wires up through the loop, through the chain, through the ring, through the canopy and through the

screw collar loop and through the nipple on the mounting strap.

6. Tie the ground wires from fixture and from outlet box to the ground screw on the mounting strap. Connect the wire

without writing on it (with raised ribs) from the fixture to the white wire (neutral wire) from the supply circuit.

Connect the wire with writing on it from the fixture to the black wire (live wire) from the supply circuit. Cover the

connections using provided wire connectors. Position wires back inside outlet box.

7. Place the canopy over the nipple all the way to the ceiling and tighten the ring onto the screw collar loop until the

canopy is held firmly against the ceiling.

8. Screw the nipple B into the bushing. Place the bottom cover over the nipple B, using the finial to secure them.

9. Unscrew the socket rings from the sockets. Place the shades over the sockets, refasten the socket rings to secure the

shade.

10. Install the bulbs(Not included). Turn on the power.

A Satco Product

PAGE 1
ASSEMBLY INSTRUCTION SKU#60/4145, 60/4165, 60/4146, 60/4166 NOTE: Please consult a qualified electrician if you are not certain of the installation or service. CAUTION: Before starting the installation or service, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box. 1. Carefully unpack the fixture, lay out all parts on a clean surface. 2. Fasten the mounting strap onto the outlet box by using provided 2 outlet box screws. 3. Fasten the loop to the nipple A.
PAGE 2
INSTRUCCIÓN DE ASAMBLEA SKU#60/4145, 60/4165, 60/4146, 60/4166 NOTE: Por favor, Consulte con un electricista cafificado en caso de que esté seguro de la instalación. CAUCIÓN: Antes de comenzar la instalación, cortar la electricidad mediante apagar el cortacircuitos o quitar el fusible desde la caja de fusible. 1. Desempaquetar cuidadosamente la instalación, disponer todas las piezas sobre una superficie límpia. 2.