Assembly Instruction

1of2
Package Contents
A
Fixture Body
x1
(1)CandelabraBaseBulb60WMaximum
ToolsRequired:Flatheadscrewdriver, Phillips screwdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
LightSource:
EstimatedAssemblyTime:
Preparation:
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement
parts.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
2.4 mm
13 Ga
Crossbar
Assembly
x1
B
Crystal
x1
C
STEP 1 - Install the Crossbar Assembly to Outlet Box and Adjust
the length of the Nipple
A. Attach the Crossbar Assembly (A) to the Outlet Box with the head of
the Green Ground Screw facing you. Secure it with Outlet Box
Screws (not included), tighten until snug
B. Adjust the hex nut and lock washer underside of the crossbar to the
middle of the nipple.
C. Remove the mounting ball from the nipple. Place the backplate and
Fixture Body (C) over the nipple against the wall to determine the
correct position of the nipple. Thread the mounting ball onto the
nipple. Adjust the nipple to allow the backplate and Fixture Body (C)
to rest against the wall when held in place by the mounting ball.
D. Remove the backplate and Fixture Body (C) . Tighten the lock
washer and the hex nut against the crossbar to secure in place.
.
Figure 1
Outlet Box
Green Ground
Screw
Nipple
Outlet Box Screw
(not included)
Hex Nut and
Lock Washer
Mounting Ball
C
A
STEP 2 - Wire Connections
A. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Figure 2
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from fixture
Bare, or Green
Ground wire
from outlet box
OR
Ground wire
from fixture
Green Ground Screw
on the Crossbar
STEP 3 Install Fixture Body-
A. Place the backplate and Fixture Body (C) over the nipple onto the
outlet box. Secure by threading the mounting ball onto the nipple.
Hand tighten until snug.
Backplate
Outlet Box
Backplate
C
Mounting Ball
Nipple
Figure 3
Assembly Instruction Sheet
GND