Assembly Instruction

ManualsBrandsCharlton Home ManualsLightingEndres 1-Light Lantern Head

1of2

Warnings and Cautions

Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.

These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly

recommend that a licensed, professional electrician perform the installation.

Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.

(1)A21MediumBasebulb150WMaximumor

(1)MediumBaseVintageBulbisrecommendedbutnotsupplied.

20-30minutes

Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtoensureallpartsare

present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement

parts.

LightSource:

EstimatedAssembly Time:

Preparation:

ToolsRequired:Flatheadscrewdriver,Phillipsscrewdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.

Package Contents

Mounting Screw

Fixture Body

Glass

Panel

STEP 1 Remove Cage from Fixture Body-

A. Unlock lock screws on the bottom of the Fixture Body (C) and

remove the cage from the .Fixture Body (C)

Cage

Figure 1

Lock Screw

Socket Assembly

STEP 2 Install Glass Panels-

A. Insert the Glass Panel (B) into the

cage. Attach the top edge of the

Glass Panel (B) to the slot in the top

of the cage. Fold tabs in the bottom

edge of the cage to secure Glass

Panels (B).

Figure 2

Slot

Cage

Tab

STEP 3 Install the Bulb and Cage-

A. Insert the bulb onto the socket and

screw snugly into place.

B. Place the cage back onto the Fixture

Body (C) and secure with previously

removed lock screws. Hand tighten

until snug.

Socket

Lock Screw

Vintage Bulb

(recommended

but not Supplied)

Figure 3

Cage

Assembly Instruction Sheet

Summary of content (2 pages)

PAGE 1
Assembly Instruction Sheet Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses. Light Source: (1) A21 Medium Base bulb 150W Maximum or (1) Medium Base Vintage Bulb is recommended but not supplied. Estimated Assembly Time: 20-30 minutes Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts are present.
PAGE 2
STEP 8 - Attach the fixture to the Post Mount STEP 4 - Mark the Location for the 3 Mounting Holes A. Place the light fixture onto the post and mark the location of the 3 mounting holes on the fixture fitter onto the post with the marking pen. A. Place the fixture on the post lining up the mounting holes on the fixture fitter with the holes on the post. Use the Fixture Mounting Screws (A) to Fitter attach the fixture to the post.