Assembling & Installation Instructions

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
MOUNTING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old
fixture and all hardware from Junction Box.
2. Carefully unpack your new fixture and lay out all the parts
on a clear area. Take care not to lose any small parts
necessary for installation.
3.
Thread the pipe screw part way into the center hole of the
single bar and secure with hex n ut.
4. Attach the single bar to the junction box using two box
screws. The side of the single bar marked “GND” must face
out.
5. While holding the plate(A) assembly towards the ceiling,
connect the electrical wires as Shown in Fig.2, making
sure that all wire nuts are secured. You may have to wrap
the connections with electrical tape. If your outlet has a
ground wire (green or bare copper), connect the fixture
ground wire to it. Otherwise connect fixture’s ground wire
directly to the Mounting strap with the green screw
provided. After wires are connected, tuck them carefully
inside the Junction Box.
6. Raise plate(A) onto the junction box, aligning pipe screw on
single bar with center hole in plate and lock it securely with
the ball nut(D).
7. Attach the glass shade(B)
to bottom of the lamp socket,
then
lock it securely with ring(C)
until sung
.
8. Install the light bulbs in accordance with the fixture’s
specifications. NOTE: DO NOT EXCEED THE
SPECIFIED WATTAGE.
Your installation is now complete. Return power to the
junction box and test the fixture.
Fig.1
Junction Box
Box
screw
Pipe screw
Single
bar
A
B
C
D
Fig.2
MIN 90
℃ SUPPLY CONDUCTORS
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE
Listed
U
L
R
ASSEMBLING & INSTALLATION INSTRUCTIONS
For Ceiling Mount Fixtures