Caution : You must read this before you proceed Table Label Description QTY A Table Top 1 B Table Leg（preinstalled Leveller) 4 C Support Ring 1 Description QTY 1 Nut 13 2 Spanner 1 Label Picture Picture Page 1 OF 9
Before Beginning Assembly: Overview Table Top (A) Table Leg (B) Support Ring This Table has multiple parts and may require up to some 20 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions herebelow to familiarise the parts and steps before assembly. Step 1 A B C Unpack and place all parts on a clean, non-marring surface.
Step 2 B 1 B B A A A X4 Lay the Table Top(A) facedown, onto a clean, non-marring surface. Attach one of the Table Legs(B) to the the Table Top(A) using Nuts(D) with Spanner(2). Repeat this method to assemble the remaining of 3 table legs. Loosely tighten Nuts (D). Step 3 B C 1 C B Attach the Support Ring(C) to Table Legs(B) using Nuts(1) with Spanner(2). Loosely tighten Nuts. Step 4 Stand the Table and test for wobbleness.
Questions & Answers about Proposition 65 • What is Proposition 65? Proposition 65 requires businesses to provide warnings to Californians about significant exposures to chemicals that cause cancer, birth defects or other reproductive harm. These chemicals can be in the products that Californians purchase, in their homes or workplaces, or that are released into the environment.
Caution : You must read this before you proceed Chair Label Description QTY A Chair Seat 1 B Leg Frame 1 Description QTY Nut 5 Label 1 Picture Picture Page 5 OF 9
2 Spanner 1 Before Beginnin g Assembl y: Chair Seat Chair Leg Frame This Dining chair has multiple parts and may require up to some 20 minutes to assemble. To give you an overview of the Dining chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions herebelow to familiarise the parts and steps before assembly.
Step 1 B A Unpack and place all parts on a clean, non-marring surface. Position the Leg Frame (B) resting on its front, as show in Pix B, above. Step 2 A B 1 A B A B Lay the Chair seat(A) being floor facing, onto a flat soft clean surface . Attach the Leg Frame(B) to the the Chair Seat(A) using Nuts(1) with Spanner(2). Loosely tighten Nuts.
Step 3 Place the chair on a LEVEL SURFACE to see if it wobbles. If it wobbles, lift the chair to some 30cm to 50cm height from the ground. Keep your feet and toes well away from the drop zone. Drop the chair freely and vertically with the four legs, hitting the ground, at the same time. This Drop Test will help to ensure that all the bolts and gaps to all reach full alignment status. Test again for evenness on a LEVEL SURFACE. If no wobbles found, lay down the chair and proceed to tighten all the bolts.
Questions & Answers about Proposition 65 • What is Proposition 65? Proposition 65 requires businesses to provide warnings to Californians about significant exposures to chemicals that cause cancer, birth defects or other reproductive harm. These chemicals can be in the products that Californians purchase, in their homes or workplaces, or that are released into the environment.
