Installation & Assembly

ASSEMBLY INSTRUCTION

NOTE: Please consult a qualified electrician if you are not certain of installation or servicing.

CAUTION: Before starting installation or servicing, disconnect power by turning off the circuit breaker or by

removing the fuse at the fuse box.

1. Carefully unpack the fixture, lay out all parts on a clean surface.

2. Attach Mounting Strap to Outlet Box using the provided outlet box screws.

3. Fasten Rod A onto the Nipple, Rod B onto Rod A and Rod C onto Rod B. Weave fixture wires up through

the Canopy. Hang Hook to Loop.

4. Connect the wires with writing on it from fixture to the black wire (live wire) from the supply circuit.

Connect the wire without writing on it (with raised ribs) from fixture to the white wire (neutral wire) from

the supply circuit. Cover the connections using provided Wire Connectors. Tie the ground wire from

fixture and from Outlet Box to the Ground Screw on the Mounting Strap. Position wires back inside Outlet

Box.

5. Place the Canopy to the Outlet Box by aligning the protruding Mounting Screws all the way through the

Canopy and tighten the fixture using Lock Nuts provided. Fasten the fixture until it is firmly held.

6. Unscrew Socket Ring from Socket. Place Shade over Socket and reattach the Socket Ring to Socket until

the Shade is held firmly to the fixture. Install the Bulb. (Not included).

7. Turn on power.

PAGE 1
ASSEMBLY INSTRUCTION NOTE: Please consult a qualified electrician if you are not certain of installation or servicing. CAUTION: Before starting installation or servicing, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box. 1. Carefully unpack the fixture, lay out all parts on a clean surface. 2. Attach Mounting Strap to Outlet Box using the provided outlet box screws. 3. Fasten Rod A onto the Nipple, Rod B onto Rod A and Rod C onto Rod B.
PAGE 2
INSTRUCCIÓN DE ASAMBLEA NOTE: Por favor, Consulte con un electricista cafificado en caso de que esté seguro de la instalación. CAUCIÓN: Antes de comenzar la instalación, cortar la electricidad mediante apagar el cortacircuitos o quitar el fusible desde la caja de fusible. 1. Desempaquetar cuidadosamente la instalación, disponer todas las piezas sobre una superficie límpia. 2. Abroche la correa de montaje a la caja de salida usando los dos tornillos de la caja de salida. 3.