Assembly Instruction

ASSEMBLY INSTRUCTION
NOTE: Please consult a qualified electrician if you are not certain of installation or service.
CAUTION: Before starting installation or service, disconnect the power by turning off the circuit breaker or by
removing the fuse at the fuse box.
1. Carefully unpack the fixture, lay out all parts on a clean surface.
2. Thread the longer mounting screws into mounting holes on mounting strap.(to be fully tightened later)
3. Fasten the mounting strap onto the outlet box by using provided 2 outlet box screws.
4. Tie ground wire from outlet box and from fixture to the ground screw on the mounting strap. Connect white
wire from fixture to white wire (neutral wire) from supply circuit. Connect black wire from fixture to black
wire (live wire) from supply circuit. Cover connections using provided wire connectors.
5. Place the canopy to the outlet box. Allow the heads of mounting screws come out through the large ends of
keyholes. Twist the canopy until the heads of mounting screws slide into narrow ends of keyholes. Tighten
mounting screws to secure the canopy.
6. Unscrew the finial from the nipple. Then screw the nipple into the bushing using the hex nut.
7. Install the bulbs ( Included ).
8. Place the shade and the washer over the nipple, screw the finial over the nipple.
9. Turn on power.