Installation & Assembly

1. Wesuggestinstallationbyalicensedelectrician.

2. Pleasereadtheinstructioncarefullyandsaveitasyoumayneeditatlatertime.

3. Beforeyoustart,NEVERattemptanyworkwithoutshuttingofftheelectricityuntiltheworkisdone.A).Gotothemain

fuse,orcircuitbreaker,boxinyourhome.Placethemainpowerswitchinthe“OFF”position.B).Placethewallswitchin

the“OFF”position.

4. Mountingsurfaceshouldbeclean,dry,flat,strongenoughand1/4”largerthanthecanopyonallside.Anygapsbetween

themountingsurfaceandcanopyexceeding3/16”shouldbecorrectedasrequired.

5. Makesurethattheceilingorwallcanstandtheweightofthelampbeforefixture.

6. Makesurethevoltageyouareusingis120V.Themaximumwattageis60Wperbulb.

7. Keepthelampawayfromacidicandbasicobjectsincaseofdamagingthesurfaceofthelamp.

8. Whenreplacingbulb,youshouldturnofforunplugthelampandyoumustwaituntilitiscoolasbulbsgethotquickly.

9. Thesafetyinstructionsappearinginthismanualarenotmeanttocoverallpossibleconditionsthatmayoccur.Itmustbe

understoodthatcommonsense,cautionandcaremustbeusedwithanyelectricalproducts.



Imageforfinishedproduct:



AccessoriesList:



WARNING(Toreducetheriskoffire,electricshock,orinjurytopersons):

PAGE 1
WARNING (To reduce the risk of fire, electric shock, or injury to persons): 1. We suggest installation by a licensed electrician. 2. Please read the instruction carefully and save it as you may need it at later time. 3. Before you start, NEVER attempt any work without shutting off the electricity until the work is done. A). Go to the main fuse, or circuit breaker, box in your home. Place the main power switch in the “OFF” position. B). Place the wall switch in the “OFF” position. 4.
PAGE 2
Installation Procedures: 1. Open the package and take out all the parts or accessories, then place them on a clean flat place. 2. Fix the glass ⑤ on the metal shelf ⑦. 3. Fix the mounting part ① to the outlet box using screw ②. 4. Connect wire from lamp to the outlet box，wiring instructions as below. 5. Fix the canopy ③ to the wall using screw cap ④. 6. Install bulb ⑧ (not including). 7. Check everything installed correctly, then you can turn on the light.