Installation & Assembly

ManualsBrandsCharlton Home Manuals5 Piece Kitchen & Dining Room SetsAnjelita 4 - Person Dining Set

Flat Washer

11 pcs. (+1 extra)

Key Wrench

1 pc.

Small

Key Wrench

1 pc.

M x 403.5

Wood Screw

4 pcs. (+1 extra)

M6 x 40

Head Cap Bolt

(short)

3 pcs. (+1 extra)

M6 x 50

Head Cap Bolt

4 pcs. (+1 extra)

M6 x 70

Head Cap Bolt

(long)

4 pcs. (+1 extra)

Spring Washer

11 pcs. (+1 extra)

Hardware List

Part List

Tool(s) required for assembly: Phillips screwdriver

IMPORTANT

Carefully remove all the parts from the carton and

place them individually on a soft cloth to prevent

scratches or other damage.

Carefully and strictly follow these assembly instructions

to ensure a completed product as designed.

Do not use power tools above 8 volts to assemble.

Chair

Side Stretcher

2 pc.

Leg

1 pc.

Leg

1 pc.

Back Frame

1 pc.

Seat

1 pc.

Center Stretcher

1 pc.

Summary of content (4 pages)

PAGE 1
Chair IMPORTANT Carefully remove all the parts from the carton and place them individually on a soft cloth to prevent scratches or other damage. Carefully and strictly follow these assembly instructions to ensure a completed product as designed. Do not use power tools above 8 volts to assemble. Part List A. Seat 1 pc. B. Side Stretcher 2 pc. C. Center Stretcher 1 pc. D. Leg 1 pc. E. Leg 1 pc. F. Back Frame 1 pc. Hardware List Spring Washer 11 pcs. (+1 extra) Small Key Wrench 1 pc. Key Wrench 1 pc.
PAGE 2
Assembly Instructions 2/3 IMPORTANT Use a soft cloth between these parts and the floor. Do not use power tools above 8 volts to assemble. Do not tighten all the bolts and wood screws until each part is properly assembled. Keep Hex Wrench in a safe place as the bolts may need to be tightened up in the future.
PAGE 3
Assembly Instructions 3/3 Flat Washer Spring Washer Head Cap Bolt (long) Head Cap Bolt (short) Spring Washer Flat Washer Wood Screw F STEP 2 Attach Back Frame (F) to the unit with Flat Washers, Spring Washers, Head Cap Bolts (short), Head Cap Bolts (long) and Wood Screws, tightening the bolts only halfway. (See Figures 4 and 5) Tighten bolts used in all steps.
PAGE 4
CARE INSTRUCTIONS NEVER NEVER use glass cleaners on finished furniture. Ammonia chemically attacks the finish. allow liquids to remain on furniture. Absorption causes parts to warp and split and finishes to delaminate. Do not use power tools above 8 volts to assemble. Do not place in direct sunlight. Do not write directly on surface. PREVENT CRACKING PREVENT FADING PREVENT MARKING Do not place hot objects on surface. Do not use rubber based placemats. Do not use commercial waxes and polishes.