Instructions
MAXIMUM WATTAGE - (1) GU-32 WATT SELF BALLASTED COMPACT FLUORESCENT LAMP (SBCFL)
1. Disconnectmainpowersupplyatthebreakerbox.DONOTturnpoweroff atthewallswitchonly.
CAUTION: FAILURE TO DISCONNECT MAIN ELECTRICAL POWER MAY RESULT IN
SERIOUS INJURY.
5. Securexturetowallbyattachingnylonmountingnutto2”threadedrod.Tightenforsecuret,butdonot
tightensomuchthatyoustripthethreads.Covermountingnutwithweatherproof vinylcap.
Thiscompletesyourinstallation.PleaseconsultourFixtureCaresuggestions
includedinthispackageorndthemundertheCustomerSupportlinkonour
LIGHT FIXTURE
BLACKBLACK
WHITEWHITE
GROUND WIRE
GREEN OR BARE
GROUND WIRE
GREEN OR BARE
WIRE NUT
OR OTHER
ACCEPTABLE
CONNECTOR
120 VOLT POWER SUPPLY
ALWAYS CONNECT BLACK TO BLACK,
WHITE TO WHITE, AND BARE OR GREEN
GROUNDING CONNECTORS
INSTRUCTIONS:
FULL SIZE INVERTED WALL LANTERN
Mark means lamp contains Mercury. Follow disposal laws.
See www.lamprecycle.org
Hg
BALLAST AND LAMP REPLACEMENT INSTRUCTIONS
Product contains an integrated Lamp/Ballast combination. To remove, grasp plastic area on each side of bulb area and rotate coun-
terclockwise. Replace with MAX 32W SBCFL(GU-24) that is marked with the UL and C, US Logo. Use SBCFL marked - Not for use
where directly exposed to water. Do not use SBCFL marked - Not for use in totally enclosed luminaire.
website.
4. Placextureonwallwith2”threadedrodprotrudingthroughcenterholeonbackplateof xture.Adjust
depthof threadedrodbyscrewingitinsotheapproximately1”of rodisleftshowing.
6. Screw11/2”threadedrodintodecorativenial.Insertthreadedrodthroughholeincanopy.
Fromtheinsideof thecanopy,placerubber”O”ring,thenhexjamnutonthreadedrod,
andtighten.
7. Placelampinsocket:Be sure not to exceed maximum wattage of 32 watts.
8. Attachcanopyontopxtureandsecureusing(2)8/32x3/8matchingknurledthumbscrews.
9. ApplySiliconeCaulkcompletelyaroundthexturebackplateforawatertightseal.
10. Turnonmainpower.
3. Usingwireconnectors,splicewiresfromboxtoxturewires.Besuretoattachblacktoblack,whitetowhite,
andgroundtoground.
2. Using (2) stainless steel junction box screws, attach PATENTED MOUNTING CROSSBAR to the electrical
box. Once secured, screw 2” threaded rod into center hole of crossbar. Proper depth will be adjusted later.