Installation

ManualsBrandsCharlton Home ManualsCeiling LightsHarrisburg 1 - Light Unique / Statement Bowl Pendant

INSTALLATION AND SAFETY INSTRUCTIONS

FOR YOUR SAFETY

ASSEMBLY

GENERAL

WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU

ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED

OR THE CIRCUIT BREAKER OFF.

You don’t need special tools to install this fixture. Be sure to follow the

steps in the order given. Under no circumstances should a fixture be

hung on house electrical wires, nor should a swag type fixture be

installed on a ceiling which contains a radiant type heating system.

Read instructions carefully.

If you are unclear as to how to proceed,

consult a qualified electrician.

Carefully remove the fixture from the carton and check that all parts

are included, as shown in Figure 1, 2 & 3. Be careful not to misplace

any of the screws or parts which are needed to install this fixture.

FIGURE 1

CANOPY (H)

CANOPY (O)

*NOT SUPPLIED

CHAIN (S)

FIXTURE LOOP (I)

LOOP (K)

HOOK (M)

GLASS (J)

RING (L)

FINIAL

ASSEMBLY (P)

ARM

Attach loop (I) to top of fixture (if applicable).

STEP 1:

WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC

SHOCK OR PERSONAL INJURY, MOUNT TO OUTLET BOX

OR SUPPORTING SYSTEM ABLE TO SUPPORT THE

WEIGHT OF THE FIXTURE.

nstallation And Safety

Instruction

Fill In Item Number On Carton And

File This Sheet For Fixture Reference. ITEM#_________

GREEN

GROUNDING

SCREW (D)

*OUTLET BOX

SCREWS (K)

FLAT

STRAP (B)

OFFSET

STRAP (C)

*WIRE

CONNECTORS

MOUNTING

SCREWS (I)

*GROUND WIRE

*OUTLET BOX

GROUNDING AND MOUNTING BAR LOCK UP

FIGURE 2

*NOT INCLUDED

*OUTLET BOX

*WIRE

CONNECTORS

MOUNTING

SCREWS (I)

CAPNUTS (F)

FOR FLUSH MOUNT

STEP 1:

Remove: fixture loop (I), fixture canopy from fixture, feed fixture

wires through center hole of canopy (O). Secure canopy (O) to

fixture by installing lock washer (F) and nut (G) over center nipple.

Summary of content (2 pages)

PAGE 1
INSTALLATION AND SAFETY INSTRUCTIONS ASSEMBLY FOR YOUR SAFETY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED OR THE CIRCUIT BREAKER OFF. Carefully remove the fixture from the carton and check that all parts are included, as shown in Figure 1, 2 & 3. Be careful not to misplace any of the screws or parts which are needed to install this fixture. STEP 1: GENERAL You don’t need special tools to install this fixture.
PAGE 2
INSTALLATION IMPORTANT: DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX. STEP 1: Hold mounting bar with flat strap (B) behind offset strap (C). Rotate straps so they are at right angles to one another. STEP 2: Insert fixture mounting screws (I) in threaded holes of offset strap (C). Run screws all the way down to the heads. B. Take your fixture wire(s) from group A and place evenly against the black wire from the outlet box. DO NOT twist wires together before using wire connectors. C.