Installation & Assembly

PAGE 2 OF 3
A. CHEST
1 SET
PARTS IDENTIFICATION
STEP 1
STEP 2
1.1) Unscrew the pull from the back of drawer front.
Complete
1.1) Align & fasten the pull to drawer front using screw
and fully tighten with Phillips head screw driver (NOT INCLUDED)
ASSEMBLY TIPS:
1 . Remove hardware from box and sort by size.
1 . Don’t attempt to repair or modify parts that are broken or defective. Please contact the
store immediately.
2 . This product is for home use only and not intended for commercial establishment.
2 . Please check to see that all hardware and parts are present prior to start of assembly.
3 . Please follow attached instructions in the same sequence as numbered to ensure fast & easy assembly.
!
Warning !
NOTE: PHILLIPS HEAD SCREW DRIVER IS REQUIRED IN THE ASSEMBLY PROCESS. HOWEVER
MANUFACTURER DOES NOT PROVIDE THIS ITEM.
ASSEMBLY INSTRUCTIONS